Crystal Lake III wind project was set up in Iowa, USA It was brought online in 2010 and is owned by Florida Power & Light Company (FPL).
It is near Winnebago County.
See below for data.
Wind farms, as a general rule require wind speeds of 4.5 metres per second or more.
The very best destination for something such as Crystal Lake III is a steady supply of non-turbulent wind. An essential aspect of turbine siting is moreover admission to local demand or transmission capaWinnebago County.
Before building, Crystal Lake III was probably screened on the foundation of a wind atlas, and validated with wind measurements. Meteorological wind data alone is usually not adequate for exact siting of a large wind power project.
Collection of site-specific data for wind speed and direction would have been imperative to determining site potential as a way to fund the project. Winds around Winnebago County are analysed for over a year or so plus the introduction of detailed maps. Only then are wind turbines installed.
Altitude would also possess a part to performwithin a project like Crystal Lake III. This is because of drag The boost in velocity with altitude is most remarkable close to the surface and is affected by topography, surface roughness, and upwind limitations such as trees or buildings. Velocity rises with altitude and is more evident near land and is altered by terrain, surface and hurdles.
Usually, the increase of wind speeds with increasing height follows a wind profile power law, which anticipates that wind speed rises proportionately to the seventh root of altitude. Doubling the altitude of a turbine, then, enhances the expected wind speeds by 10%, and the estimated power by 34%.
In general, a length of 7D (7 × Rotor Diameter of the Wind Turbine) is defined between each turbine in a fully developed wind farm. But micrositing maximizes placement, specifically in hilly areas.
Crystal Lake III turbines are connected via medium voltage lines and communications.
At a substation, this medium-voltage electric energy is elevated in voltage with a transformer for link with the high voltage transmission system. Building of a land-based wind farm requires installation of the collector system and substation, and possibly access roads to each and every turbine site.
Facts about Crystal Lake III wind farm
- Name: Crystal Lake III
- Wind turbine Supplier: Alstom, Model: ECO80-1.67MW, Units: 25,
- Country: USA
- Developer: NextEra Energy
- State: Iowa
- City: Winnebago County
- Owner: Florida Power & Light Company (FPL)