Byers Auto wind project was set up in Ohio, USA It was in fact brought online in 2010 and is owned by Byers Auto.
It is near .
See below for data.
Wind farms, as a general rule need wind speeds of 4.5 metres per second or more.
A great destination for a project like Byers Auto could have a near constant flow of non-turbulent wind throughout the year, with a minimum probability of sudden effective bursts of wind. Additionally, you wouldn’t get a turbine Byers Auto like Byers Auto associated if Byers Auto was not built near local demand or transmission capa.
Before construction, Byers Auto was probably screened on the foundation of a wind atlas, and validated with wind measurements. However, Byers Auto wind farm might have needed more than just meteorological data and measurements.
Site information around would have been a major aspect in the ‘development’ final decision Winds around are examined for over a year or so plus the development of detailed maps. Only then are wind turbines installed.
Altitude would also have a part to playin a project like Byers Auto. This is because of drag The rise in velocity with altitude is most extraordinary at the surface and is affected by geography, surface roughness, and upwind obstructions such as trees or buildings. Velocity increases with altitude and is also more pronounced near land and is changed by landscape, surface and hurdles.
Ordinarily, the rise of wind speeds with increasing height follows a wind profile power law, which predicts that wind speed rises proportionately to the seventh root of altitude. Increasing the elevation of a turbine, then, raises the expected wind speeds by 10%, and the anticipated power by 34%.
In general, a distance of 7D (7 × Rotor Diameter of the Wind Turbine) is set between each turbine in a fully developed wind farm. But this is not always the way it is in hilly areas.
Individual turbines at Byers Auto are interlocked with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, this medium-voltage electric energy is enhanced in voltage with a transformer for connection to the high voltage transmission system. Building of a land-based wind farm requires installing of the collector system and substation, and perhaps roads to each turbine site.
Facts about Byers Auto wind farm
- Name: Byers Auto
- Wind turbine Supplier: Neg Micon, Model: NM60/1000, Units: 5,
- Country: USA
- State: Ohio
- Owner: Byers Auto