Buffalo Gap II wind project was installed in Texas, USA It was in fact brought online in 2007 and is owned by AES Corporation.
It is near Taylor County.
See below for data.
As a rule, economic wind power generators require a wind speed of 4.5 m/s (16 km/h) or greater.
The very best destination for something similar to Buffalo Gap II would be a steady supply of non-turbulent wind. An important factor of turbine siting is moreover admittance to local demand or transmission capaTaylor County.
During the planning stages the Buffalo Gap II wind farm would’ve been checked and endorsed through wind measurements. Meteorological wind data alone is usually not sufficient for exact siting of a large wind power project.
Collection of site-specific data for wind speed and direction might have been essential to determining site potential in order to finance the project. Local winds are frequently checked for a year or more, and comprehensive wind maps built before wind generators are installed.
The wind hits sooner at higher altitudes due to the reduced effect of drag. The rise in velocity with altitude is most extraordinary close to the surface and is affected by landscape, surface roughness, and upwind limitations such as trees or buildings. Velocity grows with altitude and is also more pronounced near land and is altered by topography, surface and limitations.
Typically, the increase of wind speeds with increasing elevation follows a wind profile power law, which anticipates that wind speed rises proportionately to the seventh root of altitude. Increasing the height of a turbine, then, increases the predicted wind speeds by 10%, and the anticipated power by 34%.
The distance of 7x Rotor Diameter is placed between each turbine, ie they’re spaced out in order that they don’t affect one another. But micrositing increases placement, specially in hilly areas.
Individual turbines at Buffalo Gap II are connected with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, it medium-voltage electric current is improved in voltage with a transformer for link with the high voltage transmission system. Building of a land-based wind farm requires installation of the collector system and substation, and probably access roads to each and every turbine site.
Facts about Buffalo Gap II wind farm
- Name: Buffalo Gap II
- Wind turbine Supplier: General Electric, Model: 1.85MW, Units: 135,
- Country: USA
- Developer: AES Corporation
- State: Texas
- City: Taylor County
- Owner: AES Corporation