Blue Canyon VI wind project was set up in Oklahoma, USA It was finished in 2011 and is owned by EDP Renewables North America.
It is near Caddo County.
See below for data.
As a rule, economic wind machines require a wind speed of 4.5 m/s (16 km/h) or greater.
The best location for something similar to Blue Canyon VI would be a steady supply of non-turbulent wind. Additionally, you wouldn’t get a turbine EDP Renewables North America like EDP Renewables North America associated if Blue Canyon VI was not built near local demand or transmission capaCaddo County.
During the planning stages the Blue Canyon VI wind farm would’ve been checked and authenticated through wind measurements. However, Blue Canyon VI wind farm might have needed more than simply meteorological data and measurements.
Collection of site-specific data for wind speed and direction could have been essential to determining site potential as a way to finance the project. Winds around Caddo County are analysed for over a year or so alongside the development of detailed maps. Only then are wind turbines installed.
The wind blows more quickly at higher altitudes due to the reduced effect of drag. The surge in velocity with altitude is most dramatic at the surface and is impacted by geography, surface roughness, and upwind obstructions such as trees or buildings. Velocity boosts with altitude and it is more evident near land and is changed by landscape, surface and hurdles.
Typically, the growth of wind speeds with growing elevation follows a wind profile power law, which predicts that wind speed rises proportionately to the seventh root of altitude. Doubling the height of a turbine, then, boosts the expected wind speeds by 10%, and the expected power by 34%.
In general, a distance of 7D (7 × Rotor Diameter of the Wind Turbine) is about between each turbine in a fully developed wind farm. However this is not always the case in hilly areas.
Blue Canyon VI turbines are connected via medium voltage lines and communications.
At a substation, this particular medium-voltage electric current is elevated in voltage with a transformer for connection to the high voltage transmission system. Construction of a land-based wind farm requires installing of the collector system and substation, and perhaps roads to each and every turbine site.
Facts about Blue Canyon VI wind farm
- Name: Blue Canyon VI
- Wind turbine Supplier: Vestas Wind Systems, Model: V80-1.8 MW, Units: 84,
- Country: USA
- Developer: Horizon Wind Inc.
- State: Oklahoma
- City: Caddo County
- Owner: EDP Renewables North America