Bitworks wind project was installed in Arkansas, USA It was in fact brought online in 2003 and is owned by Bitworks, Inc..
It is near Washington County.
See below for data.
As a rule, economic wind power generators require a wind speed of 4.5 m/s (16 km/h) or greater.
The best destination for a project like Bitworks would have a near constant flow of non-turbulent wind throughout the year, having a minimum chances of abrupt potent bursts of wind. An essential aspect of turbine siting is also admittance to local requirement or transmission capaWashington County.
Before construction, Bitworks was probably screened on the basis of a wind atlas, and validated with wind measurements. However, Bitworks wind farm might have needed more than just meteorological data and measurements.
Assortment of site-specific data for wind speed and direction might have been important to determining site potential in order to finance the project. Winds around Washington County are examined for at least a year or so plus the introduction of detailed maps. Only then are wind turbines installed.
The wind hits more rapidly at greater altitudes because of the reduced influence of drag. The boost in velocity with altitude is most remarkable close to the surface and is affected by geography, surface roughness, and upwind limitations such as trees or buildings. Velocity increases with altitude and is also more evident near land and is altered by terrain, surface and obstacles.
Almost always, the growth of wind speeds with raising height follows a wind profile power law, which predicts that wind speed rises proportionately to the seventh root of altitude. Increasing the altitude of a turbine, then, enhances the anticipated wind speeds by 10%, and the estimated power by 34%.
The distance of 7x Rotor Diameter is placed between each turbine, ie they’re spaced out so they really don’t affect each other. But micrositing maximizes placement, specially in hilly areas.
Bitworks turbines are linked via medium voltage lines and communications.
At a substation, this kind of medium-voltage electric energy is enhanced in voltage using a transformer for connection to the high voltage transmission system. Development of a land-based wind farm requires installation of the collector system and substation, and probably roads to each and every turbine site.
Facts about Bitworks wind farm
- Name: Bitworks
- Wind turbine Supplier: Siemens, Model: SWT3.0-101, Units: 35,
- Country: USA
- Developer: Bitworks, Inc.
- State: Arkansas
- City: Washington County
- Owner: Bitworks, Inc.