AMP-Ohio/Green Mountain Energy Wind Farm I wind farm is situated in Ohio, USA. It was in fact brought online in 2003 and is owned by Bowling Green.
It is near Bowling Green.
See below for data.
Wind farms, as a general rule call for wind speeds of 4.5 metres per second or higher.
A perfect place for a project like AMP-Ohio/Green Mountain Energy Wind Farm I might have a near constant flow of non-turbulent wind all year round, having a minimum likelihood of abrupt powerful bursts of wind. Additionally, you wouldn’t get a turbine Bowling Green like Bowling Green involved if AMP-Ohio/Green Mountain Energy Wind Farm I was not built near local demand or transmission capaBowling Green.
During the planning stages the AMP-Ohio/Green Mountain Energy Wind Farm I wind farm would’ve been checked and validated through wind measurements. Meteorological wind data alone is usually not adequate for exact siting of a large wind power project.
Assortment of site-specific data for wind speed and direction would have been essential to determining site potential to be able to fund the project. Local winds are often watched for a year or more, and comprehensive wind maps created before wind generators are installed.
Altitude would also have a part to playin a project like AMP-Ohio/Green Mountain Energy Wind Farm I. This is due to drag The increase in velocity with altitude is most remarkable near the surface and is affected by geography, surface roughness, and upwind obstacles such as trees or buildings. Velocity grows with altitude and it is more distinct near land and is transformed by geography, surface and obstacles.
Normally, the increase of wind speeds with increasing height follows a wind profile power law, which forecasts that wind speed rises proportionately to the seventh root of altitude. Doubling the elevation of a turbine, then, increases the expected wind speeds by 10%, and the expected power by 34%.
In general, a distance of 7D (7 × Rotor Diameter of the Wind Turbine) is set between each turbine in a fully developed wind farm. However this might not be the situation in hilly areas.
AMP-Ohio/Green Mountain Energy Wind Farm I turbines are connected via medium voltage lines and communications.
At a substation, that medium-voltage electric current is elevated in voltage using a transformer for link with the high voltage transmission system. Construction of a land-based wind farm requires installation of the collector system and substation, and possibly access roads to every turbine site.
Facts about AMP-Ohio/Green Mountain Energy Wind Farm I wind farm
- Name: AMP-Ohio/Green Mountain Energy Wind Farm I
- Wind turbine Supplier: Vestas Wind Systems, Model: V80/1.8, Units: 2,
- Country: USA
- Developer: AMP Ohio
- State: Ohio
- City: Bowling Green
- Owner: Bowling Green