Adair (Shafer Systems) wind farm is situated in Iowa, USA. It was finished in 1994 and is owned by Shafer Systems.
It is near .
See below for data.
As a rule, economic wind turbines require a wind speed of 4.5 m/s (16 km/h) or bigger.
The very best location for something similar to Adair (Shafer Systems) would be a steady availability of non-turbulent wind. Additionally, you wouldn’t get a turbine Shafer Systems like Shafer Systems involved if Adair (Shafer Systems) was not built near local demand or transmission capa.
During the planning stages the Adair (Shafer Systems) wind farm would have been checked and confirmed through wind measurements. However, Adair (Shafer Systems) wind farm would have needed more than merely meteorological data and measurements.
Site data around is a major factor in the ‘development’ choice Local winds are often watched for a year or more, and detailed wind maps built before wind generators are installed.
The wind hits speedier at higher altitudes because of the reduced influence of drag. The rise in velocity with altitude is most dramatic close to the surface and is affected by landscape, surface roughness, and upwind limitations such as trees or buildings. Velocity rises with altitude and is more evident near land and is changed by topography, surface and obstructions.
Ordinarily, the increase of wind speeds with raising elevation follows a wind profile power law, which forecasts that wind speed rises proportionately to the seventh root of altitude. Doubling the elevation of a turbine, then, boosts the anticipated wind speeds by 10%, and the predicted power by 34%.
The distance of 7x Rotor Diameter is placed between each turbine, ie they’re spaced out to make sure they don’t affect one another. But micrositing optimizes placement, specifically in hilly areas.
Individual turbines at Adair (Shafer Systems) are connected with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, that medium-voltage electric current is elevated in voltage with a transformer for connection to the high voltage transmission system. Development of a land-based wind farm requires installation of the collector system and substation, and probably access roads to every turbine site.
Facts about Adair (Shafer Systems) wind farm
- Name: Adair (Shafer Systems)
- Wind turbine Supplier: Vestas Wind Systems, Model: 0.23MW, Units: 1,
- Country: USA
- State: Iowa
- Owner: Shafer Systems