Benthead Farm wind project was set up in Southern Scotland, UK It was created in 2013 and is owned by .
It is near Kilwinning.
See below for data.
In most cases, economic wind power generators require a wind speed of 4.5 m/s (16 km/h) or greater.
The best destination for something like Benthead Farm is a steady availability of non-turbulent wind. Additionally, you would not get a turbine like involved if Benthead Farm was not built near local demand or transmission capaKilwinning.
During the planning stages the Benthead Farm wind farm would have been checked and endorsed through wind measurements. Meteorological wind data alone is usually not sufficient for precise siting of a large wind power project.
Site data around Kilwinning would have been a major factor in the ‘development’ conclusion Local winds are often examined for a year or more, and detailed wind maps built before wind generators are set up.
Altitude would also have a part to playwithin a project like Benthead Farm. This is because of drag The surge in velocity with altitude is most dramatic near the surface and is impacted by landscape, surface roughness, and upwind limitations such as trees or buildings. Velocity rises with altitude and is more distinct near land and is altered by landscape, surface and obstructions.
Commonly, the growth of wind speeds with escalating elevation follows a wind profile power law, which predicts that wind speed rises proportionately to the seventh root of altitude. Increasing the altitude of a turbine, then, raises the expected wind speeds by 10%, and the predicted power by 34%.
In general, a range of 7D (7 × Rotor Diameter of the Wind Turbine) is set between each turbine in a fully developed wind farm. But micrositing optimizes placement, specifically in hilly areas.
Individual turbines at Benthead Farm are connected with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, this kind of medium-voltage electric energy is enhanced in voltage with a transformer for connection to the high voltage transmission system. Building of a land-based wind farm requires setting up the collector system and substation, and perhaps access roads to every turbine site.
Facts about Benthead Farm wind farm
- Name: Benthead Farm
- Wind turbine Supplier: Vestas Wind Systems, Model: V82/1.65MW, Units: 122,
- Country: UK
- Developer: Locogen
- State: Southern Scotland
- City: Kilwinning