Eksebo Kraft wind project was installed in Kalmar County, Sweden It was created in 2002 and is owned by .
It is near Henning.
See below for data.
Wind farms, as a general rule demand wind speeds of 4.5 metres per second or more.
The best destination for something like Eksebo Kraft is a steady availability of non-turbulent wind. An important factor of turbine siting is also access to local requirement or transmission capaHenning.
During the planning stages the Eksebo Kraft wind farm would have been checked and confirmed through wind measurements. However, Eksebo Kraft wind farm might have needed more than just meteorological data and measurements.
Assortment of site-specific data for wind speed and direction could have been imperative to determining site potential to be able to finance the project. Winds around Henning are evaluated for over a year or so alongside the introduction of detailed maps. Only then are wind turbines installed.
Altitude would also have a part to playin a project like Eksebo Kraft. This is because of drag The increase in velocity with altitude is most extraordinary at the surface and is affected by geography, surface roughness, and upwind hurdles such as trees or buildings. Velocity increases with altitude and is also more distinct near land and is transformed by landscape, surface and hurdles.
Typically, the increase of wind speeds with raising height follows a wind profile power law, which forecasts that wind speed rises proportionately to the seventh root of altitude. Increasing the height of a turbine, then, boosts the anticipated wind speeds by 10%, and the expected power by 34%.
In general, a range of 7D (7 × Rotor Diameter of the Wind Turbine) is about between each turbine in a fully developed wind farm. But micrositing increases placement, specifically in hilly areas.
Individual turbines at Eksebo Kraft are interlocked with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, it medium-voltage electric current is enhanced in voltage using a transformer for link with the high voltage transmission system. Building of a land-based wind farm requires installing of the collector system and substation, and probably roads to each turbine site.
Facts about Eksebo Kraft wind farm
- Name: Eksebo Kraft
- Wind turbine Supplier: Enercon, Model: E70/2000, Units: 9,
- Country: Sweden
- Developer: Vestas Wind Systems
- State: Kalmar County
- City: Henning