Åmliden II wind project was set up in Västerbotten County, Sweden It was finished in 2012 and is owned by HgCapital.
It is near Åmliden mountain in the municipality of Malå.
See below for data.
Wind farms, as a general rule demand wind speeds of 4.5 metres per second or higher.
An ideal place for a project like Åmliden II might have a near constant flow of non-turbulent wind all year round, having a minimum likelihood of sudden potent bursts of wind. Additionally, you would not get a turbine HgCapital like HgCapital included if Åmliden II was not built near local demand or transmission capaÅmliden mountain in the municipality of Malå.
During the planning stages the Åmliden II wind farm would have been checked and validated through wind measurements. However, Åmliden II wind farm would have needed more than merely meteorological data and measurements.
Site information around Åmliden mountain in the municipality of Malå is a major aspect in the ‘development’ final decision Winds around Åmliden mountain in the municipality of Malå are analysed for at least a year or so plus the creation of detailed maps. Only then are wind turbines installed.
Altitude would also possess a part to playwithin a project like Åmliden II. This is because of drag The boost in velocity with altitude is most extraordinary at the surface and is impacted by topography, surface roughness, and upwind limitations such as trees or buildings. Velocity grows with altitude and is more obvious near land and is altered by terrain, surface and obstacles.
Usually, the increase of wind speeds with raising height follows a wind profile power law, which forecasts that wind speed rises proportionately to the seventh root of altitude. Doubling the elevation of a turbine, then, increases the anticipated wind speeds by 10%, and the estimated power by 34%.
In general, a range of 7D (7 × Rotor Diameter of the Wind Turbine) is scheduled between each turbine in a fully developed wind farm. However this may not be the way it is in hilly areas.
Åmliden II turbines are connected via medium voltage lines and communications.
At a substation, this medium-voltage electric energy is elevated in voltage using a transformer for link with the high voltage transmission system. Construction of a land-based wind farm requires installation of the collector system and substation, and possibly access roads to each turbine site.
Facts about Åmliden II wind farm
- Name: Åmliden II
- Wind turbine Supplier: Vestas Wind Systems, Model: V100-1.8MW, Units: 6,
- Country: Sweden
- Developer: Nordisk Vindkraft
- State: Västerbotten County
- City: Åmliden mountain in the municipality of Malå
- Owner: HgCapital