Cuesta Mañera wind project was set up in Palencia, Spain It was created in 2007 and is owned by .
It is near Ampudia.
See below for data.
Wind farms, as a general rule demand wind speeds of 4.5 metres per second or higher.
The best destination for something such as Cuesta Mañera is a steady supply of non-turbulent wind. An important factor of turbine siting is moreover admittance to local requirement or transmission capaAmpudia.
Before building, Cuesta Mañera was almost certainly screened on the basis of a wind atlas, and validated with wind specifications. However, Cuesta Mañera wind farm might have needed more than merely meteorological data and measurements.
Collection of site-specific data for wind speed and direction would have been vital to determining site potential as a way to finance the project. Winds around Ampudia are evaluated for at least a year or so alongside the introduction of detailed maps. Only then are wind turbines installed.
The wind blows faster at higher altitudes as a result of reduced influence of drag. The surge in velocity with altitude is most extraordinary near the surface and is affected by topography, surface roughness, and upwind hurdles such as trees or buildings. Velocity grows with altitude and it is more pronounced near land and is transformed by geography, surface and obstacles.
Typically, the growth of wind speeds with escalating elevation follows a wind profile power law, which forecasts that wind speed rises proportionately to the seventh root of altitude. Increasing the elevation of a turbine, then, increases the anticipated wind speeds by 10%, and the expected power by 34%.
The distance of 7x Rotor Diameter is placed between each turbine, ie they are spaced out so they don’t affect each other. But micrositing increases placement, particularly in hilly areas.
Individual turbines at Cuesta Mañera are interconnected with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, this particular medium-voltage electric energy is improved in voltage with a transformer for link with the high voltage transmission system. Building of a land-based wind farm requires installing of the collector system and substation, and probably access roads to each and every turbine site.
Facts about Cuesta Mañera wind farm
- Name: Cuesta Mañera
- Wind turbine Supplier: Vestas Wind Systems, Model: NM44/750, Units: 25,
- Country: Spain
- Developer: Renovalia Energy
- State: Palencia
- City: Ampudia