Cortijo de Guerra II wind farm is located in Cádiz, Spain. It was brought online in 2010 and is owned by Enhol Group (Grupo Enhol).
It is near Puerto Real.
See below for data.
Wind farms, as a general rule require wind speeds of 4.5 metres per second or more.
The very best location for something such as Cortijo de Guerra II would be a steady supply of non-turbulent wind. Additionally, you wouldn’t get a turbine Enhol Group (Grupo Enhol) like Enhol Group (Grupo Enhol) involved if Cortijo de Guerra II was not built near local demand or transmission capaPuerto Real.
During the planning stages the Cortijo de Guerra II wind farm would have been checked and validated through wind measurements. However, Cortijo de Guerra II wind farm would have needed more than merely meteorological data and measurements.
Collection of site-specific data for wind speed and direction might have been essential to determining site potential to be able to fund the project. Local winds are often examined for a year or more, and detailed wind maps created before wind generators are installed.
Altitude would also have a part to playwithin a project like Cortijo de Guerra II. This is due to drag The surge in velocity with altitude is most spectacular close to the surface and is affected by geography, surface roughness, and upwind hurdles such as trees or buildings. Velocity rises with altitude and is also more obvious near land and is altered by terrain, surface and obstructions.
Wind speeds increasing with altitude is part of a wind energy law. This forecasts wind speed rises with the 7th root of altitude. Increasing the altitude of a turbine, then, raises the anticipated wind speeds by 10%, and the estimated power by 34%.
In general, a length of 7D (7 × Rotor Diameter of the Wind Turbine) is set between each turbine in a fully developed wind farm. But this is not always the situation in hilly areas.
Cortijo de Guerra II turbines are connected via medium voltage lines and communications.
At a substation, it medium-voltage electric energy is elevated in voltage using a transformer for connection to the high voltage transmission system. Construction of a land-based wind farm requires setting up the collector system and substation, and perhaps access roads to every turbine site.