Conesa II wind project was set up in Tarragona, Spain It was finished in 2011 and is owned by Iberdrola.
It is near Conesa, Forès Conca de Barberà.
See below for data.
As a rule, economic wind power generators require a wind speed of 4.5 m/s (16 km/h) or higher.
A perfect position for a project like Conesa II would have a near constant flow of non-turbulent wind year round, having a minimum chances of sudden powerful bursts of wind. Additionally, you would not get a turbine Iberdrola like Iberdrola associated if Conesa II was not built near local demand or transmission capaConesa, Forès Conca de Barberà.
Before building, Conesa II was most likely screened on the foundation of a wind atlas, and validated with wind specifications. Meteorological wind data alone is usually not sufficient for accurate siting of a large wind power project.
Site data around Conesa, Forès Conca de Barberà is a major aspect in the development conclusion Local winds are often checked for a year or more, and detailed wind maps created before wind generators are installed.
Altitude would also possess a part to performwithin a project like Conesa II. This is because of drag The boost in velocity with altitude is most spectacular close to the surface and is impacted by landscape, surface roughness, and upwind hurdles such as trees or buildings. Velocity increases with altitude and it is more distinct near land and is altered by topography, surface and limitations.
Commonly, the growth of wind speeds with escalating elevation follows a wind profile power law, which predicts that wind speed rises proportionately to the seventh root of altitude. Increasing the elevation of a turbine, then, raises the anticipated wind speeds by 10%, and the predicted power by 34%.
In general, a range of 7D (7 × Rotor Diameter of the Wind Turbine) is defined between each turbine in a fully developed wind farm. But micrositing optimizes placement, specially in hilly areas.
Conesa II turbines are linked via medium voltage lines and communications.
At a substation, it medium-voltage electric current is enhanced in voltage with a transformer for link with the high voltage transmission system. Development of a land-based wind farm requires setting up the collector system and substation, and possibly roads to every turbine site.
Facts about Conesa II wind farm
- Name: Conesa II
- Wind turbine Supplier: Mitsubishi Corporation, Model: 0.6MW, Units: 41,
- Country: Spain
- Developer: Gamesa, Gerr Grupo Energetico XXI
- State: Tarragona
- City: Conesa, Forès Conca de Barberà
- Owner: Iberdrola