Conesa I wind project was set up in Tarragona, Spain It was in fact brought online in 2011 and is owned by .
It is near Conesa Conca de Barberà.
See below for data.
As a general rule, economic wind machines require a wind speed of 4.5 m/s (16 km/h) or more.
The best location for something like Conesa I would be a steady availability of non-turbulent wind. An important factor of turbine siting is also admission to local demand or transmission capaConesa Conca de Barberà.
During the planning stages the Conesa I wind farm would’ve been checked and validated through wind measurements. However, Conesa I wind farm might have needed more than just meteorological data and measurements.
Site data around Conesa Conca de Barberà is a major element in the development final decision Local winds are often watched for a year or more, and comprehensive wind maps created before wind generators are installed.
Altitude would also possess a part to playin a project like Conesa I. This is due to drag The surge in velocity with altitude is most spectacular close to the surface and is impacted by geography, surface roughness, and upwind limitations such as trees or buildings. Velocity grows with altitude and is more distinct near land and is transformed by landscape, surface and obstructions.
Ordinarily, the increase of wind speeds with increasing elevation follows a wind profile power law, which anticipates that wind speed rises proportionately to the seventh root of altitude. Increasing the altitude of a turbine, then, enhances the predicted wind speeds by 10%, and the predicted power by 34%.
In general, a range of 7D (7 × Rotor Diameter of the Wind Turbine) is defined between each turbine in a fully developed wind farm. But micrositing maximizes placement, specifically in hilly areas.
Conesa I turbines are linked via medium voltage lines and communications.
At a substation, this medium-voltage electric energy is elevated in voltage with a transformer for link with the high voltage transmission system. Development of a land-based wind farm requires installation of the collector system and substation, and perhaps roads to each and every turbine site.
Facts about Conesa I wind farm
- Name: Conesa I
- Wind turbine Supplier: Suzlon Energy, Model: S88/2100, Units: 24,
- Country: Spain
- Developer: Gamesa, Gerr Grupo Energetico XXI
- State: Tarragona
- City: Conesa Conca de Barberà