Contim wind project was installed in Vila Real, Portugal It was brought online in 2010 and is owned by .
It is near Contim and Viade de Baixo, in the municipality of Montalegre.
See below for data.
As a general rule, economic wind machines require a wind speed of 4.5 m/s (16 km/h) or bigger.
The very best destination for something such as Contim is a steady availability of non-turbulent wind. An important factor of turbine siting is furthermore admission to local demand or transmission capaContim and Viade de Baixo, in the municipality of Montalegre.
Before construction, Contim was most likely screened on the basis of a wind atlas, and validated with wind specifications. However, Contim wind farm might have needed more than merely meteorological data and measurements.
Assortment of site-specific data for wind speed and direction might have been vital to determining site potential to be able to finance the project. Winds around Contim and Viade de Baixo, in the municipality of Montalegre are examined for over a year or so alongside the creation of detailed maps. Only then are wind turbines installed.
The wind hits quicker at greater altitudes due to the reduced influence of drag. The increase in velocity with altitude is most remarkable close to the surface and is impacted by topography, surface roughness, and upwind limitations such as trees or buildings. Velocity rises with altitude and is also more distinct near land and is transformed by geography, surface and limitations.
Normally, the increase of wind speeds with growing elevation follows a wind profile power law, which anticipates that wind speed rises proportionately to the seventh root of altitude. Increasing the elevation of a turbine, then, increases the expected wind speeds by 10%, and the estimated power by 34%.
In general, a range of 7D (7 × Rotor Diameter of the Wind Turbine) is scheduled between each turbine in a fully developed wind farm. But micrositing increases placement, specially in hilly areas.
Contim turbines are linked via medium voltage lines and communications.
At a substation, this kind of medium-voltage electric current is elevated in voltage using a transformer for link with the high voltage transmission system. Development of a land-based wind farm requires installation of the collector system and substation, and perhaps roads to each turbine site.
Facts about Contim wind farm
- Name: Contim
- Wind turbine Supplier: Senvion, Model: MM70_2000kW, Units: 6,
- Country: Portugal
- Developer: ENEOP – Eólicas de Portugal
- State: Vila Real
- City: Contim and Viade de Baixo, in the municipality of Montalegre