Carreço e Outeiro II wind project was set up in Viana do Castelo, Portugal It was in fact brought online in 2010 and is owned by .
It is near Carreço and Outeiro.
See below for data.
In most cases, economic wind machines require a wind speed of 4.5 m/s (16 km/h) or bigger.
A perfect place for a project like Carreço e Outeiro II would have a near constant flow of non-turbulent wind all year round, having a minimum probability of abrupt effective bursts of wind. Additionally, you wouldn’t get a turbine like associated if Carreço e Outeiro II was not built near local demand or transmission capaCarreço and Outeiro.
During the planning stages the Carreço e Outeiro II wind farm would’ve been checked and endorsed through wind measurements. However, Carreço e Outeiro II wind farm would have needed more than merely meteorological data and measurements.
Site info around Carreço and Outeiro would have been a major aspect in the ‘development’ conclusion Winds around Carreço and Outeiro are analysed for at least a year or so plus the introduction of detailed maps. Only then are wind turbines installed.
The wind hits swifter at higher altitudes as a result of reduced effect of drag. The increase in velocity with altitude is most dramatic close to the surface and is impacted by topography, surface roughness, and upwind limitations such as trees or buildings. Velocity increases with altitude and is more pronounced near land and is changed by topography, surface and obstacles.
Usually, the rise of wind speeds with growing height follows a wind profile power law, which predicts that wind speed rises proportionately to the seventh root of altitude. Increasing the altitude of a turbine, then, enhances the anticipated wind speeds by 10%, and the estimated power by 34%.
In general, a distance of 7D (7 × Rotor Diameter of the Wind Turbine) is defined between each turbine in a fully developed wind farm. But micrositing increases placement, specifically in hilly areas.
Carreço e Outeiro II turbines are connected via medium voltage lines and communications.
At a substation, this particular medium-voltage electric current is enhanced in voltage with a transformer for link with the high voltage transmission system. Development of a land-based wind farm requires installing of the collector system and substation, and perhaps access roads to every turbine site.
Facts about Carreço e Outeiro II wind farm
- Name: Carreço e Outeiro II
- Wind turbine Supplier: Enercon, Model: E53/800, Units: 17,
- Country: Portugal
- Developer: ENEOP – Eólicas de Portugal
- State: Viana do Castelo
- City: Carreço and Outeiro