Darlowo Wind Energy Center II wind project was installed in West Pomerania (Zachodniopomorskie), Poland It was finished in 2013 and is owned by .
It is near Darlowo.
See below for data.
Wind farms, as a general rule call for wind speeds of 4.5 metres per second or more.
The very best destination for something like Darlowo Wind Energy Center II is a steady supply of non-turbulent wind. An essential aspect of turbine siting is moreover admission to local requirement or transmission capaDarlowo.
Before building, Darlowo Wind Energy Center II was almost certainly screened on the basis of a wind atlas, and validated with wind measurements. Meteorological wind data alone is usually not sufficient for precise siting of a large wind power project.
Assortment of site-specific data for wind speed and direction might have been important to determining site potential in order to fund the project. Winds around Darlowo are examined for over a year or so alongside the creation of detailed maps. Only then are wind turbines installed.
The wind blows swifter at greater altitudes as a result of reduced influence of drag. The rise in velocity with altitude is most extraordinary near the surface and is affected by geography, surface roughness, and upwind hurdles such as trees or buildings. Velocity increases with altitude and it is more obvious near land and is changed by landscape, surface and limitations.
Wind speeds growing with altitude is part of a wind energy law. This predicts wind speed rises with the 7th root of altitude. Doubling the elevation of a turbine, then, raises the predicted wind speeds by 10%, and the anticipated power by 34%.
The distance of 7x Rotor Diameter is placed between each turbine, ie they’re spaced out so that they don’t affect one another. But micrositing increases placement, specifically in hilly areas.
Darlowo Wind Energy Center II turbines are connected via medium voltage lines and communications.
At a substation, this kind of medium-voltage electric energy is enhanced in voltage using a transformer for connection to the high voltage transmission system. Building of a land-based wind farm requires installation of the collector system and substation, and perhaps access roads to every turbine site.
Facts about Darlowo Wind Energy Center II wind farm
- Name: Darlowo Wind Energy Center II
- Wind turbine Supplier: General Electric, Model: GE2.5-103, Units: 38,
- Country: Poland
- Developer: Invenergy, Enerco sp. z o.o.
- State: West Pomerania (Zachodniopomorskie)
- City: Darlowo