Didsiliai wind farm is situated in Klaipėda, Lithuania. It was in fact brought online in 2010 and is owned by Enercon, LHV Group.
It is near Didsiliai.
See below for data.
In most cases, economic wind generators require a wind speed of 4.5 m/s (16 km/h) or greater.
A perfect position for a project like Didsiliai might have a near constant flow of non-turbulent wind all year round, having a minimum probability of abrupt powerful bursts of wind. Additionally, you would not get a turbine Enercon, LHV Group like Enercon, LHV Group included if Didsiliai was not built near local demand or transmission capaDidsiliai.
During the planning stages the Didsiliai wind farm would have been checked and authenticated through wind measurements. Meteorological wind data alone is usually not enough for accurate siting of a large wind power project.
Assortment of site-specific data for wind speed and direction could have been essential to determining site potential in order to finance the project. Winds around Didsiliai are analysed for over a year or so plus the introduction of detailed maps. Only then are wind turbines installed.
The wind blows quicker at greater altitudes due to the reduced influence of drag. The boost in velocity with altitude is most remarkable at the surface and is affected by geography, surface roughness, and upwind hurdles such as trees or buildings. Velocity grows with altitude and is more evident near land and is altered by topography, surface and limitations.
Wind speeds raising with altitude is part of a wind energy law. This anticipates wind speed rises with the 7th root of altitude. Increasing the altitude of a turbine, then, increases the expected wind speeds by 10%, and the estimated power by 34%.
In general, a range of 7D (7 × Rotor Diameter of the Wind Turbine) is about between each turbine in a fully developed wind farm. But micrositing increases placement, specially in hilly areas.
Individual turbines at Didsiliai are interconnected with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, this kind of medium-voltage electric current is enhanced in voltage with a transformer for link with the high voltage transmission system. Building of a land-based wind farm requires installing of the collector system and substation, and possibly access roads to each and every turbine site.