Anzano di Puglia wind project was installed in Apulia, Italy It was finished in 1996 and is owned by IVPC, Eurus Energy.
It is near Foggia, Anzano di Puglia.
See below for data.
Wind farms, as a general rule call for wind speeds of 4.5 metres per second or more.
A great destination for a project like Anzano di Puglia would have a near constant flow of non-turbulent wind year round, having a minimum probability of abrupt effective bursts of wind. An essential aspect of turbine siting is furthermore admittance to local requirement or transmission capaFoggia, Anzano di Puglia.
During the planning stages the Anzano di Puglia wind farm would have been checked and endorsed through wind measurements. Meteorological wind data alone is usually not ample for correct siting of a large wind power project.
Site data around Foggia, Anzano di Puglia is a major factor in the ‘development’ final decision Local winds are often checked for a year or more, and detailed wind maps created before wind generators are set up.
The wind hits quicker at greater altitudes due to the reduced influence of drag. The surge in velocity with altitude is most spectacular at the surface and is affected by landscape, surface roughness, and upwind obstacles such as trees or buildings. Velocity boosts with altitude and it is more obvious near land and is altered by geography, surface and limitations.
Wind speeds raising with altitude is part of a wind energy law. This Apulias wind speed rises with the 7th root of altitude. Increasing the altitude of a turbine, then, enhances the anticipated wind speeds by 10%, and the anticipated power by 34%.
In general, a range of 7D (7 × Rotor Diameter of the Wind Turbine) is defined between each turbine in a fully developed wind farm. However this might not be the case in hilly areas.
Anzano di Puglia turbines are connected via medium voltage lines and communications.
At a substation, this medium-voltage electric current is enhanced in voltage using a transformer for link with the high voltage transmission system. Development of a land-based wind farm requires installing of the collector system and substation, and probably access roads to each turbine site.
Facts about Anzano di Puglia wind farm
- Name: Anzano di Puglia
- Wind turbine Supplier: Vestas Wind Systems, Model: V42 -600kW, Units: 12,
- Country: Italy
- Developer: IVPC
- State: Apulia
- City: Foggia, Anzano di Puglia
- Owner: IVPC, Eurus Energy