Ballinveny wind project was set up in Tipperary, Ireland It was completed in 2006 and is owned by .
It is near .
See below for data.
Wind farms, as a general rule require wind speeds of 4.5 metres per second or higher.
The best destination for a project like Ballinveny might have a near constant flow of non-turbulent wind year round, with a minimum likelihood of sudden effective bursts of wind. Additionally, you would not get a turbine like involved if Ballinveny was not built near local demand or transmission capa.
During the planning stages the Ballinveny wind farm would’ve been checked and confirmed through wind measurements. Meteorological wind data alone is usually not enough for precise siting of a large wind power project.
Assortment of site-specific data for wind speed and direction might have been important to determining site potential as a way to finance the project. Winds around are evaluated for over a year or so plus the development of detailed maps. Only then are wind turbines installed.
The wind hits more quickly at higher altitudes as a result of reduced influence of drag. The rise in velocity with altitude is most dramatic near the surface and is impacted by landscape, surface roughness, and upwind limitations such as trees or buildings. Velocity grows with altitude and is more evident near land and is altered by terrain, surface and obstacles.
Generally, the rise of wind speeds with increasing height follows a wind profile power law, which predicts that wind speed rises proportionately to the seventh root of altitude. Increasing the height of a turbine, then, increases the predicted wind speeds by 10%, and the predicted power by 34%.
In general, a range of 7D (7 × Rotor Diameter of the Wind Turbine) is about between each turbine in a fully developed wind farm. But micrositing optimizes placement, specifically in hilly areas.
Ballinveny turbines are connected via medium voltage lines and communications.
At a substation, this particular medium-voltage electric energy is increased in voltage with a transformer for link with the high voltage transmission system. Construction of a land-based wind farm requires installation of the collector system and substation, and perhaps roads to every turbine site.
Facts about Ballinveny wind farm
- Name: Ballinveny
- Wind turbine Supplier: Vestas Wind Systems, Model: V52-850 kW, Units: 3,
- Country: Ireland
- Developer: North Tipperary Wind Power
- State: Tipperary