Dharapuram (Selvi Spinning Mills) 0.8 MW wind project wind project was set up in Tamil Nadu, India It was completed in 2010 and is owned by Selvi Spinning Mills.
It is near Dharapuram.
See below for data.
Wind farms, as a general rule require wind speeds of 4.5 metres per second or higher.
A perfect location for a project like Dharapuram (Selvi Spinning Mills) 0.8 MW wind project might have a near constant flow of non-turbulent wind throughout the year, having a minimum chances of sudden powerful bursts of wind. An important factor of turbine siting is furthermore admission to local requirement or transmission capaDharapuram.
During the planning stages the Dharapuram (Selvi Spinning Mills) 0.8 MW wind project wind farm would have been checked and authenticated through wind measurements. Meteorological wind data alone is usually not enough for precise siting of a large wind power project.
Collection of site-specific data for wind speed and direction could have been imperative to determining site potential as a way to fund the project. Local winds are often supervised for a year or more, and comprehensive wind maps created before wind generators are installed.
The wind hits more quickly at greater altitudes as a result of reduced influence of drag. The increase in velocity with altitude is most spectacular close to the surface and is affected by topography, surface roughness, and upwind obstacles such as trees or buildings. Velocity increases with altitude and it is more distinct near land and is changed by landscape, surface and limitations.
Wind speeds growing with altitude is part of a wind energy law. This predicts wind speed rises with the 7th root of altitude. Increasing the height of a turbine, then, enhances the anticipated wind speeds by 10%, and the expected power by 34%.
In general, a distance of 7D (7 × Rotor Diameter of the Wind Turbine) is about between each turbine in a fully developed wind farm. But this isn’t necessarily the case in hilly areas.
Individual turbines at Dharapuram (Selvi Spinning Mills) 0.8 MW wind project are connected with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, this particular medium-voltage electric energy is enhanced in voltage with a transformer for link with the high voltage transmission system. Construction of a land-based wind farm requires setting up the collector system and substation, and perhaps roads to each turbine site.
Facts about Dharapuram (Selvi Spinning Mills) 0.8 MW wind project wind farm
- Name: Dharapuram (Selvi Spinning Mills) 0.8 MW wind project
- Wind turbine Supplier: Enercon India, Model: 0.8MW, Units: 1,
- Country: India
- Developer: Enercon
- State: Tamil Nadu
- City: Dharapuram
- Owner: Selvi Spinning Mills