Dhank (Elecon Engineering) 2.1MW wind project wind farm is situated in Gujarat, India. It was created in 1996 and is owned by Elecon Engineering.
It is near Rajkot.
See below for data.
As a rule, economic wind machines require a wind speed of 4.5 m/s (16 km/h) or higher.
A great place for a project like Dhank (Elecon Engineering) 2.1MW wind project might have a near constant flow of non-turbulent wind year round, with a minimum chances of sudden powerful bursts of wind. An important factor of turbine siting is moreover admission to local requirement or transmission capaRajkot.
Before development, Dhank (Elecon Engineering) 2.1MW wind project was probably screened on the basis of a wind atlas, and validated with wind specifications. Meteorological wind data alone is usually not sufficient for precise siting of a large wind power project.
Site information around Rajkot would have been a major aspect in the ‘development’ decision Winds around Rajkot are examined for over a year or so plus the introduction of detailed maps. Only then are wind turbines installed.
Altitude would also possess a part to performin a project like Dhank (Elecon Engineering) 2.1MW wind project. This is due to drag The rise in velocity with altitude is most dramatic at the surface and is affected by topography, surface roughness, and upwind hurdles such as trees or buildings. Velocity boosts with altitude and it is more evident near land and is transformed by geography, surface and obstacles.
Wind speeds escalating with altitude is part of a wind energy law. This anticipates wind speed rises with the 7th root of altitude. Increasing the elevation of a turbine, then, raises the expected wind speeds by 10%, and the predicted power by 34%.
In general, a length of 7D (7 × Rotor Diameter of the Wind Turbine) is set between each turbine in a fully developed wind farm. However this is not always the way it is in hilly areas.
Individual turbines at Dhank (Elecon Engineering) 2.1MW wind project are interlocked with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, this medium-voltage electric energy is elevated in voltage using a transformer for connection to the high voltage transmission system. Construction of a land-based wind farm requires installation of the collector system and substation, and perhaps access roads to each and every turbine site.
Facts about Dhank (Elecon Engineering) 2.1MW wind project wind farm
- Name: Dhank (Elecon Engineering) 2.1MW wind project
- Wind turbine Supplier: BHEL Nordex, Model: 0.2MW, Units: 10,
- Country: India
- Developer: Elecon Engineering
- State: Gujarat
- City: Rajkot
- Owner: Elecon Engineering