Dhank (Elecon Engineering) 0.6MW wind project wind farm is situated in Gujarat, India. It was in fact brought online in 1998 and is owned by Elecon Engineering.
It is near Jamnagar.
See below for data.
In most cases, economic wind machines require a wind speed of 4.5 m/s (16 km/h) or more.
The very best destination for something similar to Dhank (Elecon Engineering) 0.6MW wind project would be a steady supply of non-turbulent wind. An important factor of turbine siting is moreover admittance to local requirement or transmission capaJamnagar.
Before development, Dhank (Elecon Engineering) 0.6MW wind project was most likely screened on the basis of a wind atlas, and validated with wind specifications. However, Dhank (Elecon Engineering) 0.6MW wind project wind farm would have needed more than simply meteorological data and measurements.
Assortment of site-specific data for wind speed and direction could have been essential to determining site potential to be able to fund the project. Local winds are frequently checked for a year or more, and detailed wind maps created before wind generators are set up.
The wind blows more rapidly at higher altitudes as a result of reduced influence of drag. The boost in velocity with altitude is most extraordinary at the surface and is affected by landscape, surface roughness, and upwind limitations such as trees or buildings. Velocity increases with altitude and it is more pronounced near land and is altered by topography, surface and obstacles.
Normally, the increase of wind speeds with raising height follows a wind profile power law, which forecasts that wind speed rises proportionately to the seventh root of altitude. Increasing the altitude of a turbine, then, enhances the anticipated wind speeds by 10%, and the anticipated power by 34%.
The distance of 7x Rotor Diameter is placed between each turbine, ie they’re spaced out in order that they don’t affect each other. But micrositing maximizes placement, specially in hilly areas.
Individual turbines at Dhank (Elecon Engineering) 0.6MW wind project are connected with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, that medium-voltage electric current is improved in voltage with a transformer for connection to the high voltage transmission system. Development of a land-based wind farm requires installation of the collector system and substation, and perhaps roads to each turbine site.
Facts about Dhank (Elecon Engineering) 0.6MW wind project wind farm
- Name: Dhank (Elecon Engineering) 0.6MW wind project
- Wind turbine Supplier: NEPC Micon, Model: 0.225MW, Units: 8,
- Country: India
- Developer: Elecon Engineering
- State: Gujarat
- City: Jamnagar
- Owner: Elecon Engineering