Dhalgaon (Kedia Enterprises) 1.25MW wind project wind project was set up in Maharashtra, India It was finished in 2006 and is owned by Kedia Enterprises.
It is near Satara.
See below for data.
In most cases, economic wind generators require a wind speed of 4.5 m/s (16 km/h) or higher.
The very best location for something similar to Dhalgaon (Kedia Enterprises) 1.25MW wind project is a steady supply of non-turbulent wind. Additionally, you would not get a turbine Kedia Enterprises like Kedia Enterprises involved if Dhalgaon (Kedia Enterprises) 1.25MW wind project was not built near local demand or transmission capaSatara.
During the planning stages the Dhalgaon (Kedia Enterprises) 1.25MW wind project wind farm would have been checked and confirmed through wind measurements. However, Dhalgaon (Kedia Enterprises) 1.25MW wind project wind farm would have needed more than simply meteorological data and measurements.
Collection of site-specific data for wind speed and direction might have been imperative to determining site potential to be able to fund the project. Winds around Satara are evaluated for over a year or so alongside the development of detailed maps. Only then are wind turbines installed.
The wind hits speedier at greater altitudes as a result of reduced influence of drag. The boost in velocity with altitude is most extraordinary at the surface and is impacted by topography, surface roughness, and upwind hurdles such as trees or buildings. Velocity grows with altitude and is also more obvious near land and is transformed by terrain, surface and obstructions.
Wind speeds escalating with altitude is part of a wind energy law. This forecasts wind speed rises with the 7th root of altitude. Increasing the altitude of a turbine, then, increases the expected wind speeds by 10%, and the predicted power by 34%.
In general, a distance of 7D (7 × Rotor Diameter of the Wind Turbine) is set between each turbine in a fully developed wind farm. But micrositing maximizes placement, specially in hilly areas.
Dhalgaon (Kedia Enterprises) 1.25MW wind project turbines are connected via medium voltage lines and communications.
At a substation, this medium-voltage electric current is increased in voltage with a transformer for connection to the high voltage transmission system. Development of a land-based wind farm requires installation of the collector system and substation, and probably roads to each and every turbine site.
Facts about Dhalgaon (Kedia Enterprises) 1.25MW wind project wind farm
- Name: Dhalgaon (Kedia Enterprises) 1.25MW wind project
- Wind turbine Supplier: Suzlon Energy, Model: 1.25 MW, Units: 3,
- Country: India
- Developer: Suzlon Energy
- State: Maharashtra
- City: Satara
- Owner: Kedia Enterprises