Dewas (Hind Syntex Limited) 0.45MW wind project wind project was installed in Madhya Pradesh, India It was completed in 1996 and is owned by Hind Syntex Limited.
It is near Jamgod.
See below for data.
For the most part, economic wind power generators require a wind speed of 4.5 m/s (16 km/h) or larger.
The best place for a project like Dewas (Hind Syntex Limited) 0.45MW wind project might have a near constant flow of non-turbulent wind all year round, with a minimum chance of abrupt effective bursts of wind. Additionally, you wouldn’t get a turbine Hind Syntex Limited like Hind Syntex Limited involved if Dewas (Hind Syntex Limited) 0.45MW wind project was not built near local demand or transmission capaJamgod.
Before development, Dewas (Hind Syntex Limited) 0.45MW wind project was probably screened on the foundation of a wind atlas, and validated with wind measurements. Meteorological wind data alone is usually not ample for correct siting of a large wind power project.
Site data around Jamgod would have been a major factor in the ‘development’ decision Winds around Jamgod are analysed for over a year or so plus the introduction of detailed maps. Only then are wind turbines installed.
The wind hits swifter at higher altitudes due to the reduced effect of drag. The surge in velocity with altitude is most spectacular at the surface and is affected by geography, surface roughness, and upwind limitations such as trees or buildings. Velocity increases with altitude and is also more distinct near land and is altered by landscape, surface and obstacles.
Typically, the rise of wind speeds with raising height follows a wind profile power law, which forecasts that wind speed rises proportionately to the seventh root of altitude. Doubling the height of a turbine, then, increases the expected wind speeds by 10%, and the predicted power by 34%.
In general, a length of 7D (7 × Rotor Diameter of the Wind Turbine) is about between each turbine in a fully developed wind farm. But this is not always the situation in hilly areas.
Dewas (Hind Syntex Limited) 0.45MW wind project turbines are connected via medium voltage lines and communications.
At a substation, this particular medium-voltage electric energy is increased in voltage with a transformer for link with the high voltage transmission system. Development of a land-based wind farm requires installing of the collector system and substation, and possibly access roads to every turbine site.
Facts about Dewas (Hind Syntex Limited) 0.45MW wind project wind farm
- Name: Dewas (Hind Syntex Limited) 0.45MW wind project
- Wind turbine Supplier: Regen Powertech, Model: Vensys V82, Units: 34,
- Country: India
- Developer: Suzlon Energy
- State: Madhya Pradesh
- City: Jamgod
- Owner: Hind Syntex Limited