Devarkulam (Kandagiri Mills) 1.25 MW wind project wind farm is located in Tamil Nadu, India. It was finished in 2006 and is owned by Kandagiri Spinning Mills Ltd.
It is near Tirunelveli.
See below for data.
As a general rule, economic wind machines require a wind speed of 4.5 m/s (16 km/h) or greater.
The very best location for something like Devarkulam (Kandagiri Mills) 1.25 MW wind project would be a steady supply of non-turbulent wind. Additionally, you would not get a turbine Kandagiri Spinning Mills Ltd like Kandagiri Spinning Mills Ltd included if Devarkulam (Kandagiri Mills) 1.25 MW wind project was not built near local demand or transmission capaTirunelveli.
During the planning stages the Devarkulam (Kandagiri Mills) 1.25 MW wind project wind farm would’ve been checked and confirmed through wind measurements. Meteorological wind data alone is usually not adequate for exact siting of a large wind power project.
Collection of site-specific data for wind speed and direction might have been essential to determining site potential in order to fund the project. Winds around Tirunelveli are analysed for over a year or so alongside the introduction of detailed maps. Only then are wind turbines installed.
Altitude would also possess a part to playwithin a project like Devarkulam (Kandagiri Mills) 1.25 MW wind project. This is due to drag The surge in velocity with altitude is most extraordinary close to the surface and is impacted by topography, surface roughness, and upwind obstructions such as trees or buildings. Velocity increases with altitude and it is more obvious near land and is altered by landscape, surface and hurdles.
Normally, the growth of wind speeds with raising elevation follows a wind profile power law, which predicts that wind speed rises proportionately to the seventh root of altitude. Doubling the elevation of a turbine, then, enhances the predicted wind speeds by 10%, and the predicted power by 34%.
In general, a length of 7D (7 × Rotor Diameter of the Wind Turbine) is about between each turbine in a fully developed wind farm. But this may not be the situation in hilly areas.
Devarkulam (Kandagiri Mills) 1.25 MW wind project turbines are related via medium voltage lines and communications.
At a substation, this kind of medium-voltage electric energy is enhanced in voltage using a transformer for link with the high voltage transmission system. Construction of a land-based wind farm requires setting up the collector system and substation, and possibly roads to each turbine site.
Facts about Devarkulam (Kandagiri Mills) 1.25 MW wind project wind farm
- Name: Devarkulam (Kandagiri Mills) 1.25 MW wind project
- Wind turbine Supplier: Suzlon Energy, Model: S82 1.5MW, Units: 16,
- Country: India
- Developer: Suzlon Energy
- State: Tamil Nadu
- City: Tirunelveli
- Owner: Kandagiri Spinning Mills Ltd