Dedha (Jindal Fine Industries.) 1.25MW wind project wind project was installed in Rajasthan, India It was in fact brought online in 2009 and is owned by Jindal Fine Industries.
It is near Jaisalmer.
See below for data.
As a general rule, economic wind generators require a wind speed of 4.5 m/s (16 km/h) or bigger.
An ideal destination for a project like Dedha (Jindal Fine Industries.) 1.25MW wind project would have a near constant flow of non-turbulent wind all year long, having a minimum chances of abrupt potent bursts of wind. Additionally, you would not get a turbine Jindal Fine Industries like Jindal Fine Industries associated if Dedha (Jindal Fine Industries.) 1.25MW wind project was not built near local demand or transmission capaJaisalmer.
Before construction, Dedha (Jindal Fine Industries.) 1.25MW wind project was probably screened on the foundation of a wind atlas, and validated with wind measurements. However, Dedha (Jindal Fine Industries.) 1.25MW wind project wind farm might have needed more than merely meteorological data and measurements.
Site data around Jaisalmer is a major factor in the development final decision Winds around Jaisalmer are analysed for at least a year or so alongside the introduction of detailed maps. Only then are wind turbines installed.
Altitude would also possess a part to performwithin a project like Dedha (Jindal Fine Industries.) 1.25MW wind project. This is because of drag The increase in velocity with altitude is most dramatic close to the surface and is affected by topography, surface roughness, and upwind obstructions such as trees or buildings. Velocity increases with altitude and is more obvious near land and is changed by geography, surface and limitations.
Normally, the rise of wind speeds with increasing height follows a wind profile power law, which forecasts that wind speed rises proportionately to the seventh root of altitude. Increasing the height of a turbine, then, increases the predicted wind speeds by 10%, and the anticipated power by 34%.
The distance of 7x Rotor Diameter is placed between each turbine, ie they’re spaced out to make sure they don’t affect each other. But micrositing increases placement, specially in hilly areas.
Individual turbines at Dedha (Jindal Fine Industries.) 1.25MW wind project are interconnected with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, this medium-voltage electric current is improved in voltage using a transformer for link with the high voltage transmission system. Building of a land-based wind farm requires setting up the collector system and substation, and probably roads to each and every turbine site.