Dasarpatti (Prabhu Spinning) 3 MW wind project wind project was set up in Tamil Nadu, India It was finished in 2002 and is owned by Prabhu Spinning Mills Private Limited.
It is near Coimbatore.
See below for data.
Wind farms, as a general rule require wind speeds of 4.5 metres per second or higher.
The best position for a project like Dasarpatti (Prabhu Spinning) 3 MW wind project might have a near constant flow of non-turbulent wind all year round, having a minimum chance of abrupt powerful bursts of wind. An important factor of turbine siting is also admission to local requirement or transmission capaCoimbatore.
During the planning stages the Dasarpatti (Prabhu Spinning) 3 MW wind project wind farm would’ve been checked and endorsed through wind measurements. However, Dasarpatti (Prabhu Spinning) 3 MW wind project wind farm would have needed more than merely meteorological data and measurements.
Collection of site-specific data for wind speed and direction could have been imperative to determining site potential in order to finance the project. Local winds are frequently watched for a year or more, and comprehensive wind maps made before wind generators are installed.
The wind blows faster at higher altitudes due to the reduced effect of drag. The rise in velocity with altitude is most spectacular at the surface and is impacted by landscape, surface roughness, and upwind hurdles such as trees or buildings. Velocity increases with altitude and it is more distinct near land and is altered by landscape, surface and obstacles.
Commonly, the increase of wind speeds with escalating height follows a wind profile power law, which anticipates that wind speed rises proportionately to the seventh root of altitude. Doubling the elevation of a turbine, then, enhances the anticipated wind speeds by 10%, and the anticipated power by 34%.
In general, a length of 7D (7 × Rotor Diameter of the Wind Turbine) is set between each turbine in a fully developed wind farm. But micrositing maximizes placement, specifically in hilly areas.
Dasarpatti (Prabhu Spinning) 3 MW wind project turbines are connected via medium voltage lines and communications.
At a substation, that medium-voltage electric energy is elevated in voltage using a transformer for link with the high voltage transmission system. Development of a land-based wind farm requires installation of the collector system and substation, and possibly roads to every turbine site.