Chettikulam (Atlas Exports) 0.85 MW wind project wind project was installed in Tamil Nadu, India It was finished in 2005 and is owned by Atlas Export Enterprises.
It is near Tirunelveli.
See below for data.
Wind farms, as a general rule demand wind speeds of 4.5 metres per second or higher.
The best location for something like Chettikulam (Atlas Exports) 0.85 MW wind project would be a steady supply of non-turbulent wind. An important factor of turbine siting is moreover admittance to local requirement or transmission capaTirunelveli.
During the planning stages the Chettikulam (Atlas Exports) 0.85 MW wind project wind farm would have been checked and authenticated through wind measurements. However, Chettikulam (Atlas Exports) 0.85 MW wind project wind farm might have needed more than simply meteorological data and measurements.
Assortment of site-specific data for wind speed and direction could have been imperative to determining site potential in order to finance the project. Local winds are frequently checked for a year or more, and comprehensive wind maps constructed before wind generators are installed.
The wind hits sooner at higher altitudes due to the reduced influence of drag. The surge in velocity with altitude is most spectacular at the surface and is impacted by landscape, surface roughness, and upwind obstructions such as trees or buildings. Velocity grows with altitude and is also more pronounced near land and is changed by geography, surface and hurdles.
Normally, the increase of wind speeds with raising height follows a wind profile power law, which predicts that wind speed rises proportionately to the seventh root of altitude. Doubling the elevation of a turbine, then, raises the predicted wind speeds by 10%, and the anticipated power by 34%.
In general, a distance of 7D (7 × Rotor Diameter of the Wind Turbine) is defined between each turbine in a fully developed wind farm. But micrositing maximizes placement, specially in hilly areas.
Chettikulam (Atlas Exports) 0.85 MW wind project turbines are linked via medium voltage lines and communications.
At a substation, this particular medium-voltage electric current is elevated in voltage with a transformer for link with the high voltage transmission system. Building of a land-based wind farm requires installation of the collector system and substation, and perhaps roads to each and every turbine site.
Facts about Chettikulam (Atlas Exports) 0.85 MW wind project wind farm
- Name: Chettikulam (Atlas Exports) 0.85 MW wind project
- Wind turbine Supplier: Enercon, Model: E66 2MW, Units: 2,
- Country: India
- Developer: Pioneer Wincon
- State: Tamil Nadu
- City: Tirunelveli
- Owner: Atlas Export Enterprises