Bhambarwadi (Cooper Foundry) 3.2 MW wind project wind farm is located in Maharashtra, India. It was created in 2006 and is owned by Cooper Foundry Private Limited.
It is near Bhambarwadi, Sangli.
See below for data.
Wind farms, as a general rule demand wind speeds of 4.5 metres per second or higher.
An ideal location for a project like Bhambarwadi (Cooper Foundry) 3.2 MW wind project could have a near constant flow of non-turbulent wind all year long, with a minimum probability of sudden powerful bursts of wind. Additionally, you wouldn’t get a turbine Cooper Foundry Private Limited like Cooper Foundry Private Limited involved if Bhambarwadi (Cooper Foundry) 3.2 MW wind project was not built near local demand or transmission capaBhambarwadi, Sangli.
Before construction, Bhambarwadi (Cooper Foundry) 3.2 MW wind project was probably screened on the basis of a wind atlas, and validated with wind specifications. Meteorological wind data alone is usually not adequate for precise siting of a large wind power project.
Assortment of site-specific data for wind speed and direction would have been crucial to determining site potential as a way to finance the project. Winds around Bhambarwadi, Sangli are examined for over a year or so plus the introduction of detailed maps. Only then are wind turbines installed.
The wind blows speedier at greater altitudes because of the reduced influence of drag. The increase in velocity with altitude is most extraordinary at the surface and is affected by geography, surface roughness, and upwind obstacles such as trees or buildings. Velocity increases with altitude and it is more distinct near land and is transformed by geography, surface and obstacles.
Normally, the growth of wind speeds with increasing height follows a wind profile power law, which anticipates that wind speed rises proportionately to the seventh root of altitude. Doubling the height of a turbine, then, enhances the predicted wind speeds by 10%, and the estimated power by 34%.
In general, a distance of 7D (7 × Rotor Diameter of the Wind Turbine) is set between each turbine in a fully developed wind farm. But micrositing optimizes placement, particularly in hilly areas.
Individual turbines at Bhambarwadi (Cooper Foundry) 3.2 MW wind project are interconnected with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, it medium-voltage electric current is increased in voltage with a transformer for link with the high voltage transmission system. Construction of a land-based wind farm requires installation of the collector system and substation, and perhaps roads to every turbine site.
Facts about Bhambarwadi (Cooper Foundry) 3.2 MW wind project wind farm
- Name: Bhambarwadi (Cooper Foundry) 3.2 MW wind project
- Wind turbine Supplier: Enercon India, Model: 0.8MW, Units: 2,
- Country: India
- Developer: Wind World (India)
- State: Maharashtra
- City: Bhambarwadi, Sangli
- Owner: Cooper Foundry Private Limited