baroda Gaon (JLC Electromet Pvt. Ltd) 1.5MW wind project wind project was installed in Rajasthan, India It was completed in 2012 and is owned by JLC Electromet Pvt. Ltd.
It is near Jaisalmer.
See below for data.
As a general rule, economic wind power generators require a wind speed of 4.5 m/s (16 km/h) or greater.
A great location for a project like baroda Gaon (JLC Electromet Pvt. Ltd) 1.5MW wind project might have a near constant flow of non-turbulent wind throughout the year, having a minimum probability of sudden powerful bursts of wind. An essential aspect of turbine siting is moreover admittance to local requirement or transmission capaJaisalmer.
During the planning stages the baroda Gaon (JLC Electromet Pvt. Ltd) 1.5MW wind project wind farm would have been checked and confirmed through wind measurements. Meteorological wind data alone is usually not sufficient for accurate siting of a large wind power project.
Collection of site-specific data for wind speed and direction could have been essential to determining site potential to be able to finance the project. Local winds are often watched for a year or more, and detailed wind maps constructed before wind generators are set up.
The wind hits sooner at higher altitudes as a result of reduced influence of drag. The boost in velocity with altitude is most dramatic close to the surface and is impacted by topography, surface roughness, and upwind hurdles such as trees or buildings. Velocity grows with altitude and it is more evident near land and is altered by landscape, surface and hurdles.
Wind speeds increasing with altitude is part of a wind energy law. This predicts wind speed rises with the 7th root of altitude. Doubling the altitude of a turbine, then, enhances the predicted wind speeds by 10%, and the anticipated power by 34%.
In general, a distance of 7D (7 × Rotor Diameter of the Wind Turbine) is about between each turbine in a fully developed wind farm. However this isn’t necessarily the case in hilly areas.
Individual turbines at baroda Gaon (JLC Electromet Pvt. Ltd) 1.5MW wind project are interconnected with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, this particular medium-voltage electric current is increased in voltage using a transformer for connection to the high voltage transmission system. Development of a land-based wind farm requires installation of the collector system and substation, and probably access roads to every turbine site.
Facts about baroda Gaon (JLC Electromet Pvt. Ltd) 1.5MW wind project wind farm
- Name: baroda Gaon (JLC Electromet Pvt. Ltd) 1.5MW wind project
- Wind turbine Supplier: Suzlon Energy, Model: 1.5MW, Units: 1,
- Country: India
- Developer: Suzlon Energy
- State: Rajasthan
- City: Jaisalmer
- Owner: JLC Electromet Pvt. Ltd