Baramsar (Jetex Carburettors Pvt. Ltd) 0.35MW wind project wind project was installed in Rajasthan, India It was completed in 2004 and is owned by Jetex Carburettors Pvt. Ltd.
It is near Jaisalmer.
See below for data.
Wind farms, as a general rule require wind speeds of 4.5 metres per second or higher.
A great position for a project like Baramsar (Jetex Carburettors Pvt. Ltd) 0.35MW wind project would have a near constant flow of non-turbulent wind throughout the year, having a minimum probability of abrupt effective bursts of wind. An essential aspect of turbine siting is furthermore admission to local demand or transmission capaJaisalmer.
Before construction, Baramsar (Jetex Carburettors Pvt. Ltd) 0.35MW wind project was most likely screened on the basis of a wind atlas, and validated with wind measurements. However, Baramsar (Jetex Carburettors Pvt. Ltd) 0.35MW wind project wind farm might have needed more than just meteorological data and measurements.
Collection of site-specific data for wind speed and direction would have been imperative to determining site potential to be able to finance the project. Winds around Jaisalmer are examined for over a year or so plus the introduction of detailed maps. Only then are wind turbines installed.
The wind blows swifter at higher altitudes as a result of reduced effect of drag. The increase in velocity with altitude is most extraordinary near the surface and is affected by landscape, surface roughness, and upwind limitations such as trees or buildings. Velocity grows with altitude and is more pronounced near land and is transformed by landscape, surface and obstructions.
Almost always, the growth of wind speeds with raising height follows a wind profile power law, which forecasts that wind speed rises proportionately to the seventh root of altitude. Doubling the height of a turbine, then, increases the expected wind speeds by 10%, and the expected power by 34%.
In general, a length of 7D (7 × Rotor Diameter of the Wind Turbine) is about between each turbine in a fully developed wind farm. However this isn’t necessarily the case in hilly areas.
Individual turbines at Baramsar (Jetex Carburettors Pvt. Ltd) 0.35MW wind project are connected with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, it medium-voltage electric energy is enhanced in voltage with a transformer for link with the high voltage transmission system. Construction of a land-based wind farm requires installing of the collector system and substation, and probably access roads to every turbine site.
Facts about Baramsar (Jetex Carburettors Pvt. Ltd) 0.35MW wind project wind farm
- Name: Baramsar (Jetex Carburettors Pvt. Ltd) 0.35MW wind project
- Wind turbine Supplier: Suzlon Energy, Model: 1.25MW, Units: 2,
- Country: India
- Developer: Suzlon Energy
- State: Rajasthan
- City: Jaisalmer
- Owner: Jetex Carburettors Pvt. Ltd