Ayikudi (Sugavaneshwara Mill) 1.5 MW Wind project wind farm is situated in Tamil Nadu, India. It was created in 2005 and is owned by Sugavaneswara Spinning Mills.
It is near Tirunelveli.
See below for data.
Typically, economic wind generators require a wind speed of 4.5 m/s (16 km/h) or more.
The very best location for something like Ayikudi (Sugavaneshwara Mill) 1.5 MW Wind project is a steady availability of non-turbulent wind. Additionally, you would not get a turbine Sugavaneswara Spinning Mills like Sugavaneswara Spinning Mills involved if Ayikudi (Sugavaneshwara Mill) 1.5 MW Wind project was not built near local demand or transmission capaTirunelveli.
Before construction, Ayikudi (Sugavaneshwara Mill) 1.5 MW Wind project was probably screened on the foundation of a wind atlas, and validated with wind measurements. Meteorological wind data alone is usually not ample for precise siting of a large wind power project.
Assortment of site-specific data for wind speed and direction could have been vital to determining site potential as a way to finance the project. Local winds are frequently checked for a year or more, and comprehensive wind maps made before wind generators are installed.
Altitude would also possess a part to playin a project like Ayikudi (Sugavaneshwara Mill) 1.5 MW Wind project. This is due to drag The surge in velocity with altitude is most spectacular close to the surface and is affected by geography, surface roughness, and upwind obstacles such as trees or buildings. Velocity boosts with altitude and it is more obvious near land and is changed by geography, surface and obstacles.
Normally, the rise of wind speeds with increasing height follows a wind profile power law, which predicts that wind speed rises proportionately to the seventh root of altitude. Doubling the elevation of a turbine, then, enhances the expected wind speeds by 10%, and the predicted power by 34%.
In general, a length of 7D (7 × Rotor Diameter of the Wind Turbine) is defined between each turbine in a fully developed wind farm. But micrositing increases placement, specifically in hilly areas.
Individual turbines at Ayikudi (Sugavaneshwara Mill) 1.5 MW Wind project are connected with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, this medium-voltage electric current is elevated in voltage using a transformer for connection to the high voltage transmission system. Development of a land-based wind farm requires installation of the collector system and substation, and perhaps roads to every turbine site.
Facts about Ayikudi (Sugavaneshwara Mill) 1.5 MW Wind project wind farm
- Name: Ayikudi (Sugavaneshwara Mill) 1.5 MW Wind project
- Wind turbine Supplier: Neg Micon, Model: 0.75MW, Units: 1,
- Country: India
- Developer: Neg Micon
- State: Tamil Nadu
- City: Tirunelveli
- Owner: Sugavaneswara Spinning Mills