Eisenach wind project was installed in Rhineland-Palatinate, Germany It was in fact brought online in 2009 and is owned by Vortex Energy Group.
It is near Eisenach.
See below for data.
For the most part, economic wind generators require a wind speed of 4.5 m/s (16 km/h) or larger.
The very best location for something similar to Eisenach is a steady availability of non-turbulent wind. An important factor of turbine siting is also access to local requirement or transmission capaEisenach.
During the planning stages the Eisenach wind farm would have been checked and confirmed through wind measurements. Meteorological wind data alone is usually not sufficient for correct siting of a large wind power project.
Site information around Eisenach would have been a major aspect in the development final decision Winds around Eisenach are evaluated for over a year or so alongside the introduction of detailed maps. Only then are wind turbines installed.
The wind hits sooner at greater altitudes due to the reduced influence of drag. The increase in velocity with altitude is most remarkable at the surface and is impacted by landscape, surface roughness, and upwind obstacles such as trees or buildings. Velocity boosts with altitude and is also more obvious near land and is changed by topography, surface and obstacles.
Commonly, the growth of wind speeds with growing elevation follows a wind profile power law, which anticipates that wind speed rises proportionately to the seventh root of altitude. Increasing the height of a turbine, then, raises the expected wind speeds by 10%, and the estimated power by 34%.
In general, a length of 7D (7 × Rotor Diameter of the Wind Turbine) is about between each turbine in a fully developed wind farm. But this isn’t necessarily the way it is in hilly areas.
Eisenach turbines are connected via medium voltage lines and communications.
At a substation, it medium-voltage electric current is elevated in voltage with a transformer for connection to the high voltage transmission system. Construction of a land-based wind farm requires installation of the collector system and substation, and probably access roads to each and every turbine site.
Facts about Eisenach wind farm
- Name: Eisenach
- Wind turbine Supplier: Vestas Wind Systems, Model: V80/2000, Units: 10,
- Country: Germany
- Developer: Vortex Energy Group
- State: Rhineland-Palatinate
- City: Eisenach
- Owner: Vortex Energy Group