Eimersleben wind project was installed in Saxony-Anhalt, Germany It was completed in 2006 and is owned by .
It is near Eimersleben.
See below for data.
Wind farms, as a general rule call for wind speeds of 4.5 metres per second or more.
An ideal position for a project like Eimersleben would have a near constant flow of non-turbulent wind all year round, with a minimum chance of sudden effective bursts of wind. Additionally, you wouldn’t get a turbine like involved if Eimersleben was not built near local demand or transmission capaEimersleben.
During the planning stages the Eimersleben wind farm would have been checked and endorsed through wind measurements. However, Eimersleben wind farm would have needed more than just meteorological data and measurements.
Site information around Eimersleben is a major factor in the ‘development’ choice Winds around Eimersleben are evaluated for at least a year or so plus the introduction of detailed maps. Only then are wind turbines installed.
Altitude would also have a part to performin a project like Eimersleben. This is due to drag The surge in velocity with altitude is most dramatic close to the surface and is impacted by landscape, surface roughness, and upwind hurdles such as trees or buildings. Velocity boosts with altitude and it is more obvious near land and is changed by geography, surface and hurdles.
Typically, the increase of wind speeds with escalating elevation follows a wind profile power law, which forecasts that wind speed rises proportionately to the seventh root of altitude. Doubling the elevation of a turbine, then, raises the anticipated wind speeds by 10%, and the estimated power by 34%.
In general, a length of 7D (7 × Rotor Diameter of the Wind Turbine) is scheduled between each turbine in a fully developed wind farm. But micrositing maximizes placement, specifically in hilly areas.
Individual turbines at Eimersleben are interlocked with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, it medium-voltage electric energy is enhanced in voltage using a transformer for link with the high voltage transmission system. Development of a land-based wind farm requires installation of the collector system and substation, and probably access roads to each and every turbine site.
Facts about Eimersleben wind farm
- Name: Eimersleben
- Wind turbine Supplier: Senvion, Model: 3.4M104, Units: 3,
- Country: Germany
- Developer: Notus Energy, Denker & Wulf
- State: Saxony-Anhalt
- City: Eimersleben