Dittelsdorf II wind farm is situated in Saxony, Germany. It was finished in 2008 and is owned by .
It is near Dittelsdorf.
See below for data.
Wind farms, as a general rule demand wind speeds of 4.5 metres per second or more.
The very best destination for something similar to Dittelsdorf II would be a steady availability of non-turbulent wind. Additionally, you would not get a turbine like involved if Dittelsdorf II was not built near local demand or transmission capaDittelsdorf.
During the planning stages the Dittelsdorf II wind farm would have been checked and confirmed through wind measurements. However, Dittelsdorf II wind farm would have needed more than merely meteorological data and measurements.
Assortment of site-specific data for wind speed and direction would have been imperative to determining site potential as a way to finance the project. Winds around Dittelsdorf are analysed for over a year or so alongside the introduction of detailed maps. Only then are wind turbines installed.
Altitude would also have a part to playwithin a project like Dittelsdorf II. This is because of drag The surge in velocity with altitude is most dramatic at the surface and is affected by geography, surface roughness, and upwind obstructions such as trees or buildings. Velocity increases with altitude and is also more obvious near land and is changed by landscape, surface and obstacles.
Ordinarily, the growth of wind speeds with raising height follows a wind profile power law, which predicts that wind speed rises proportionately to the seventh root of altitude. Doubling the height of a turbine, then, raises the anticipated wind speeds by 10%, and the estimated power by 34%.
In general, a range of 7D (7 × Rotor Diameter of the Wind Turbine) is defined between each turbine in a fully developed wind farm. However this is not always the case in hilly areas.
Individual turbines at Dittelsdorf II are interconnected with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, that medium-voltage electric energy is elevated in voltage using a transformer for link with the high voltage transmission system. Development of a land-based wind farm requires installing of the collector system and substation, and probably access roads to each turbine site.
Facts about Dittelsdorf II wind farm
- Name: Dittelsdorf II
- Wind turbine Supplier: Bonus, Model: B62/1300, Units: 8,
- Country: Germany
- Developer: Ventotec
- State: Saxony
- City: Dittelsdorf