Dietenhofen wind project was set up in Bavaria, Germany It was completed in 2012 and is owned by Juwi.
It is near Dietenhofen.
See below for data.
As a rule, economic wind turbines require a wind speed of 4.5 m/s (16 km/h) or greater.
The best location for something like Dietenhofen is a steady supply of non-turbulent wind. An important factor of turbine siting is also admission to local requirement or transmission capaDietenhofen.
During the planning stages the Dietenhofen wind farm would’ve been checked and validated through wind measurements. Meteorological wind data alone is usually not sufficient for accurate siting of a large wind power project.
Collection of site-specific data for wind speed and direction could have been essential to determining site potential as a way to finance the project. Winds around Dietenhofen are examined for at least a year or so plus the introduction of detailed maps. Only then are wind turbines installed.
Altitude would also possess a part to playwithin a project like Dietenhofen. This is because of drag The surge in velocity with altitude is most extraordinary close to the surface and is impacted by landscape, surface roughness, and upwind obstructions such as trees or buildings. Velocity grows with altitude and is also more distinct near land and is transformed by landscape, surface and limitations.
Typically, the growth of wind speeds with raising height follows a wind profile power law, which anticipates that wind speed rises proportionately to the seventh root of altitude. Doubling the elevation of a turbine, then, increases the expected wind speeds by 10%, and the expected power by 34%.
In general, a length of 7D (7 × Rotor Diameter of the Wind Turbine) is scheduled between each turbine in a fully developed wind farm. But micrositing increases placement, specially in hilly areas.
Individual turbines at Dietenhofen are interconnected with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, this particular medium-voltage electric energy is increased in voltage with a transformer for link with the high voltage transmission system. Construction of a land-based wind farm requires installation of the collector system and substation, and possibly roads to each and every turbine site.
Facts about Dietenhofen wind farm
- Name: Dietenhofen
- Wind turbine Supplier: Vestas Wind Systems, Model: V90/ 2MW, Units: 4,
- Country: Germany
- Developer: Juwi
- State: Bavaria
- City: Dietenhofen
- Owner: Juwi