Coppenbrügge Hameln-Pyrmont wind project was installed in Lower Saxony, Germany It was in fact brought online in 2015 and is owned by cee-holding.
It is near Coppenbrügge.
See below for data.
As a rule, economic wind generators require a wind speed of 4.5 m/s (16 km/h) or more.
An ideal location for a project like Coppenbrügge Hameln-Pyrmont could have a near constant flow of non-turbulent wind all year long, with a minimum likelihood of sudden powerful bursts of wind. An essential aspect of turbine siting is furthermore access to local requirement or transmission capaCoppenbrügge.
Before development, Coppenbrügge Hameln-Pyrmont was probably screened on the basis of a wind atlas, and validated with wind measurements. Meteorological wind data alone is usually not adequate for exact siting of a large wind power project.
Site data around Coppenbrügge would have been a major aspect in the ‘development’ decision Winds around Coppenbrügge are evaluated for over a year or so alongside the development of detailed maps. Only then are wind turbines installed.
Altitude would also have a part to performin a project like Coppenbrügge Hameln-Pyrmont. This is because of drag The boost in velocity with altitude is most remarkable at the surface and is impacted by topography, surface roughness, and upwind hurdles such as trees or buildings. Velocity rises with altitude and is also more distinct near land and is transformed by topography, surface and limitations.
Usually, the rise of wind speeds with growing elevation follows a wind profile power law, which anticipates that wind speed rises proportionately to the seventh root of altitude. Increasing the height of a turbine, then, increases the predicted wind speeds by 10%, and the expected power by 34%.
In general, a distance of 7D (7 × Rotor Diameter of the Wind Turbine) is scheduled between each turbine in a fully developed wind farm. But micrositing optimizes placement, specially in hilly areas.
Individual turbines at Coppenbrügge Hameln-Pyrmont are connected with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, that medium-voltage electric current is enhanced in voltage using a transformer for link with the high voltage transmission system. Construction of a land-based wind farm requires installation of the collector system and substation, and possibly roads to each and every turbine site.
Facts about Coppenbrügge Hameln-Pyrmont wind farm
- Name: Coppenbrügge Hameln-Pyrmont
- Wind turbine Supplier: General Electric, Model: 1.5MW, Units: 4,
- Country: Germany
- Developer: Windwärts
- State: Lower Saxony
- City: Coppenbrügge
- Owner: cee-holding