Beppener Bruch wind project was set up in Lower Saxony, Germany It was in fact brought online in 2006 and is owned by .
It is near Community Thedinghausen, Verden.
See below for data.
Wind farms, as a general rule need wind speeds of 4.5 metres per second or higher.
The very best destination for something like Beppener Bruch is a steady availability of non-turbulent wind. An important factor of turbine siting is also admittance to local requirement or transmission capaCommunity Thedinghausen, Verden.
Before construction, Beppener Bruch was most likely screened on the basis of a wind atlas, and validated with wind specifications. However, Beppener Bruch wind farm would have needed more than merely meteorological data and measurements.
Site data around Community Thedinghausen, Verden would have been a major aspect in the development choice Local winds are often monitored for a year or more, and comprehensive wind maps constructed before wind generators are installed.
The wind blows sooner at greater altitudes because of the reduced influence of drag. The rise in velocity with altitude is most spectacular close to the surface and is impacted by geography, surface roughness, and upwind obstructions such as trees or buildings. Velocity increases with altitude and is also more distinct near land and is transformed by topography, surface and obstructions.
Wind speeds raising with altitude is part of a wind energy law. This predicts wind speed rises with the 7th root of altitude. Doubling the altitude of a turbine, then, boosts the expected wind speeds by 10%, and the expected power by 34%.
In general, a range of 7D (7 × Rotor Diameter of the Wind Turbine) is about between each turbine in a fully developed wind farm. But micrositing optimizes placement, specifically in hilly areas.
Individual turbines at Beppener Bruch are interconnected with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, it medium-voltage electric energy is improved in voltage using a transformer for link with the high voltage transmission system. Development of a land-based wind farm requires installation of the collector system and substation, and probably access roads to each and every turbine site.
Facts about Beppener Bruch wind farm
- Name: Beppener Bruch
- Wind turbine Supplier: Enercon, Model: E66/1800, Units: 10,
- Country: Germany
- Developer: Windstrom
- State: Lower Saxony
- City: Community Thedinghausen, Verden