Bentstreek wind project was set up in Lower Saxony, Germany It was completed in 2003 and is owned by .
It is near Bentstreek.
See below for data.
Wind farms, as a general rule demand wind speeds of 4.5 metres per second or more.
The best place for a project like Bentstreek could have a near constant flow of non-turbulent wind all year long, with a minimum likelihood of sudden powerful bursts of wind. Additionally, you would not get a turbine like involved if Bentstreek was not built near local demand or transmission capaBentstreek.
During the planning stages the Bentstreek wind farm would’ve been checked and validated through wind measurements. Meteorological wind data alone is usually not sufficient for accurate siting of a large wind power project.
Assortment of site-specific data for wind speed and direction might have been crucial to determining site potential in order to finance the project. Winds around Bentstreek are examined for over a year or so plus the introduction of detailed maps. Only then are wind turbines installed.
Altitude would also have a part to playwithin a project like Bentstreek. This is due to drag The increase in velocity with altitude is most extraordinary near the surface and is affected by topography, surface roughness, and upwind limitations such as trees or buildings. Velocity rises with altitude and it is more evident near land and is altered by terrain, surface and hurdles.
Typically, the rise of wind speeds with growing elevation follows a wind profile power law, which predicts that wind speed rises proportionately to the seventh root of altitude. Doubling the elevation of a turbine, then, increases the predicted wind speeds by 10%, and the predicted power by 34%.
In general, a length of 7D (7 × Rotor Diameter of the Wind Turbine) is scheduled between each turbine in a fully developed wind farm. But this might not be the case in hilly areas.
Individual turbines at Bentstreek are connected with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, it medium-voltage electric energy is enhanced in voltage using a transformer for connection to the high voltage transmission system. Development of a land-based wind farm requires installation of the collector system and substation, and perhaps access roads to each turbine site.
Facts about Bentstreek wind farm
- Name: Bentstreek
- Wind turbine Supplier: Vestas Wind Systems, Model: V66/1650, Units: 5,
- Country: Germany
- Developer: Enercon
- State: Lower Saxony
- City: Bentstreek