Beedenbostel wind farm is located in Lower Saxony, Germany. It was finished in 2002 and is owned by .
It is near Beedenbostel.
See below for data.
In most cases, economic wind generators require a wind speed of 4.5 m/s (16 km/h) or higher.
A great position for a project like Beedenbostel would have a near constant flow of non-turbulent wind year round, with a minimum chances of sudden potent bursts of wind. An essential aspect of turbine siting is moreover admission to local requirement or transmission capaBeedenbostel.
Before development, Beedenbostel was most likely screened on the basis of a wind atlas, and validated with wind specifications. However, Beedenbostel wind farm might have needed more than simply meteorological data and measurements.
Collection of site-specific data for wind speed and direction might have been vital to determining site potential to be able to finance the project. Local winds are often checked for a year or more, and detailed wind maps built before wind generators are set up.
The wind hits faster at higher altitudes because of the reduced influence of drag. The increase in velocity with altitude is most remarkable at the surface and is affected by topography, surface roughness, and upwind obstacles such as trees or buildings. Velocity boosts with altitude and is also more obvious near land and is changed by topography, surface and obstacles.
Almost always, the rise of wind speeds with raising height follows a wind profile power law, which predicts that wind speed rises proportionately to the seventh root of altitude. Doubling the elevation of a turbine, then, enhances the expected wind speeds by 10%, and the estimated power by 34%.
In general, a distance of 7D (7 × Rotor Diameter of the Wind Turbine) is about between each turbine in a fully developed wind farm. But micrositing increases placement, particularly in hilly areas.
Individual turbines at Beedenbostel are interlocked with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, it medium-voltage electric current is improved in voltage using a transformer for link with the high voltage transmission system. Construction of a land-based wind farm requires setting up the collector system and substation, and possibly access roads to each and every turbine site.
Facts about Beedenbostel wind farm
- Name: Beedenbostel
- Wind turbine Supplier: General Electric, Model: 1.5MW, Units: 67,
- Country: Germany
- Developer: SeeBA Energy Farming Group
- State: Lower Saxony
- City: Beedenbostel