Bad-König-Hainhaus wind project was installed in Lower Saxony, Germany It was brought online in 2005 and is owned by .
It is near .
See below for data.
Wind farms, as a general rule need wind speeds of 4.5 metres per second or higher.
The best destination for something like Bad-König-Hainhaus is a steady supply of non-turbulent wind. An important factor of turbine siting is moreover admittance to local requirement or transmission capa.
During the planning stages the Bad-König-Hainhaus wind farm would have been checked and authenticated through wind measurements. Meteorological wind data alone is usually not adequate for precise siting of a large wind power project.
Assortment of site-specific data for wind speed and direction could have been imperative to determining site potential to be able to finance the project. Winds around are evaluated for at least a year or so plus the introduction of detailed maps. Only then are wind turbines installed.
The wind hits more rapidly at greater altitudes as a result of reduced influence of drag. The increase in velocity with altitude is most spectacular at the surface and is impacted by geography, surface roughness, and upwind hurdles such as trees or buildings. Velocity grows with altitude and it is more pronounced near land and is altered by terrain, surface and obstacles.
Wind speeds escalating with altitude is part of a wind energy law. This forecasts wind speed rises with the 7th root of altitude. Doubling the elevation of a turbine, then, boosts the anticipated wind speeds by 10%, and the estimated power by 34%.
The distance of 7x Rotor Diameter is placed between each turbine, ie they are spaced out so they don’t affect one another. But this is not always the way it is in hilly areas.
Bad-König-Hainhaus turbines are connected via medium voltage lines and communications.
At a substation, that medium-voltage electric energy is enhanced in voltage with a transformer for link with the high voltage transmission system. Construction of a land-based wind farm requires installation of the collector system and substation, and perhaps access roads to each and every turbine site.
Facts about Bad-König-Hainhaus wind farm
- Name: Bad-König-Hainhaus
- Wind turbine Supplier: Enercon, Model: E70/2000, Units: 2,
- Country: Germany
- Developer: Neg Micon
- State: Lower Saxony