Altentreptow II wind project was set up in Mecklenburg-Vorpommern, Germany It was brought online in 2014 and is owned by .
It is near Altentreptow.
See below for data.
Wind farms, as a general rule call for wind speeds of 4.5 metres per second or more.
The best destination for something like Altentreptow II is a steady supply of non-turbulent wind. Additionally, you wouldn’t get a turbine like involved if Altentreptow II was not built near local demand or transmission capaAltentreptow.
Before development, Altentreptow II was probably screened on the basis of a wind atlas, and validated with wind specifications. However, Altentreptow II wind farm might have needed more than merely meteorological data and measurements.
Assortment of site-specific data for wind speed and direction would have been crucial to determining site potential to be able to fund the project. Winds around Altentreptow are evaluated for at least a year or so plus the creation of detailed maps. Only then are wind turbines installed.
The wind hits faster at higher altitudes because of the reduced effect of drag. The boost in velocity with altitude is most extraordinary near the surface and is affected by topography, surface roughness, and upwind limitations such as trees or buildings. Velocity increases with altitude and is more evident near land and is transformed by landscape, surface and limitations.
Generally, the growth of wind speeds with increasing height follows a wind profile power law, which forecasts that wind speed rises proportionately to the seventh root of altitude. Doubling the elevation of a turbine, then, raises the predicted wind speeds by 10%, and the expected power by 34%.
In general, a length of 7D (7 × Rotor Diameter of the Wind Turbine) is about between each turbine in a fully developed wind farm. But micrositing increases placement, specially in hilly areas.
Altentreptow II turbines are connected via medium voltage lines and communications.
At a substation, that medium-voltage electric current is elevated in voltage using a transformer for link with the high voltage transmission system. Development of a land-based wind farm requires setting up the collector system and substation, and perhaps access roads to each and every turbine site.
Facts about Altentreptow II wind farm
- Name: Altentreptow II
- Wind turbine Supplier: Vestas Wind Systems, Model: V90-1.8/2.0 MW, Units: 3,
- Country: Germany
- Developer: WEB Windenergie, Komesker Anlagenbau GmbH
- State: Mecklenburg-Vorpommern
- City: Altentreptow