Alpirsbach wind project was installed in Baden-Württemberg, Germany It was in fact brought online in 2013 and is owned by Erneuerbare Energien Rottenburg eG.
It is near Alpirsbach.
See below for data.
As a rule, economic wind machines require a wind speed of 4.5 m/s (16 km/h) or higher.
An ideal location for a project like Alpirsbach might have a near constant flow of non-turbulent wind throughout the year, with a minimum chance of abrupt effective bursts of wind. Additionally, you wouldn’t get a turbine Erneuerbare Energien Rottenburg eG like Erneuerbare Energien Rottenburg eG included if Alpirsbach was not built near local demand or transmission capaAlpirsbach.
During the planning stages the Alpirsbach wind farm would’ve been checked and authenticated through wind measurements. Meteorological wind data alone is usually not sufficient for accurate siting of a large wind power project.
Collection of site-specific data for wind speed and direction might have been crucial to determining site potential as a way to finance the project. Local winds are often monitored for a year or more, and comprehensive wind maps constructed before wind generators are set up.
The wind hits speedier at greater altitudes as a result of reduced effect of drag. The boost in velocity with altitude is most spectacular close to the surface and is affected by topography, surface roughness, and upwind limitations such as trees or buildings. Velocity boosts with altitude and is more distinct near land and is altered by geography, surface and hurdles.
Almost always, the increase of wind speeds with escalating height follows a wind profile power law, which forecasts that wind speed rises proportionately to the seventh root of altitude. Increasing the height of a turbine, then, increases the anticipated wind speeds by 10%, and the predicted power by 34%.
In general, a length of 7D (7 × Rotor Diameter of the Wind Turbine) is scheduled between each turbine in a fully developed wind farm. However this might not be the case in hilly areas.
Individual turbines at Alpirsbach are interconnected with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, this particular medium-voltage electric energy is increased in voltage with a transformer for link with the high voltage transmission system. Development of a land-based wind farm requires installing of the collector system and substation, and perhaps roads to each and every turbine site.
Facts about Alpirsbach wind farm
- Name: Alpirsbach
- Wind turbine Supplier: Enercon, Model: E-70 / 2,
- Country: Germany
- State: Baden-Württemberg
- City: Alpirsbach
- Owner: Erneuerbare Energien Rottenburg eG