Ajos 1 wind project was installed in Lapland, Finland It was completed in 2005 and is owned by .
It is near Northern coast of the gulf of Bothnia near the city Kemi.
See below for data.
Wind farms, as a general rule call for wind speeds of 4.5 metres per second or higher.
The best location for something similar to Ajos 1 is a steady supply of non-turbulent wind. An important factor of turbine siting is furthermore access to local demand or transmission capaNorthern coast of the gulf of Bothnia near the city Kemi.
Before building, Ajos 1 was probably screened on the basis of a wind atlas, and validated with wind measurements. However, Ajos 1 wind farm might have needed more than merely meteorological data and measurements.
Site data around Northern coast of the gulf of Bothnia near the city Kemi would have been a major element in the ‘development’ choice Winds around Northern coast of the gulf of Bothnia near the city Kemi are examined for over a year or so plus the development of detailed maps. Only then are wind turbines installed.
Altitude would also possess a part to performin a project like Ajos 1. This is due to drag The increase in velocity with altitude is most remarkable near the surface and is affected by geography, surface roughness, and upwind limitations such as trees or buildings. Velocity grows with altitude and is also more evident near land and is altered by terrain, surface and obstructions.
Wind speeds growing with altitude is part of a wind energy law. This anticipates wind speed rises with the 7th root of altitude. Increasing the altitude of a turbine, then, raises the predicted wind speeds by 10%, and the estimated power by 34%.
In general, a length of 7D (7 × Rotor Diameter of the Wind Turbine) is set between each turbine in a fully developed wind farm. But micrositing increases placement, specially in hilly areas.
Ajos 1 turbines are related via medium voltage lines and communications.
At a substation, this particular medium-voltage electric energy is increased in voltage with a transformer for connection to the high voltage transmission system. Development of a land-based wind farm requires setting up the collector system and substation, and perhaps access roads to each and every turbine site.
Facts about Ajos 1 wind farm
- Name: Ajos 1
- Wind turbine Supplier: WinWinD, Model: WWD-3-90, Units: 1,
- Country: Finland
- Developer: WinWinD
- State: Lapland
- City: Northern coast of the gulf of Bothnia near the city Kemi