Bolike II wind project was set up in Inner Mongolia, China It was in fact brought online in 2008 and is owned by .
It is near Chifeng.
See below for data.
Wind farms, as a general rule require wind speeds of 4.5 metres per second or more.
The best location for something like Bolike II is a steady supply of non-turbulent wind. Additionally, you would not get a turbine like associated if Bolike II was not built near local demand or transmission capaChifeng.
During the planning stages the Bolike II wind farm would’ve been checked and validated through wind measurements. However, Bolike II wind farm would have needed more than simply meteorological data and measurements.
Site data around Chifeng would have been a major factor in the ‘development’ decision Winds around Chifeng are examined for at least a year or so alongside the introduction of detailed maps. Only then are wind turbines installed.
Altitude would also possess a part to playin a project like Bolike II. This is because of drag The boost in velocity with altitude is most dramatic near the surface and is affected by landscape, surface roughness, and upwind obstacles such as trees or buildings. Velocity grows with altitude and is more pronounced near land and is altered by landscape, surface and obstacles.
Typically, the rise of wind speeds with growing elevation follows a wind profile power law, which anticipates that wind speed rises proportionately to the seventh root of altitude. Doubling the altitude of a turbine, then, enhances the expected wind speeds by 10%, and the predicted power by 34%.
In general, a distance of 7D (7 × Rotor Diameter of the Wind Turbine) is scheduled between each turbine in a fully developed wind farm. But micrositing increases placement, specifically in hilly areas.
Individual turbines at Bolike II are connected with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, that medium-voltage electric current is enhanced in voltage using a transformer for link with the high voltage transmission system. Building of a land-based wind farm requires installing of the collector system and substation, and perhaps access roads to each and every turbine site.