Digby Neck wind project was set up in Nova Scotia, Canada It was in fact brought online in 2010 and is owned by Emera.
It is near Digby County.
See below for data.
As a general rule, economic wind generators require a wind speed of 4.5 m/s (16 km/h) or more.
The best destination for a project like Digby Neck might have a near constant flow of non-turbulent wind throughout the year, having a minimum chances of sudden powerful bursts of wind. An essential aspect of turbine siting is also admittance to local demand or transmission capaDigby County.
During the planning stages the Digby Neck wind farm would’ve been checked and endorsed through wind measurements. However, Digby Neck wind farm might have needed more than simply meteorological data and measurements.
Collection of site-specific data for wind speed and direction could have been essential to determining site potential as a way to finance the project. Winds around Digby County are examined for over a year or so plus the development of detailed maps. Only then are wind turbines installed.
The wind hits speedier at greater altitudes as a result of reduced effect of drag. The boost in velocity with altitude is most remarkable close to the surface and is impacted by topography, surface roughness, and upwind hurdles such as trees or buildings. Velocity rises with altitude and is also more pronounced near land and is changed by terrain, surface and obstructions.
Ordinarily, the growth of wind speeds with raising height follows a wind profile power law, which predicts that wind speed rises proportionately to the seventh root of altitude. Increasing the altitude of a turbine, then, enhances the predicted wind speeds by 10%, and the predicted power by 34%.
In general, a length of 7D (7 × Rotor Diameter of the Wind Turbine) is about between each turbine in a fully developed wind farm. But this is not always the situation in hilly areas.
Individual turbines at Digby Neck are interlocked with a medium voltage (usually 34.5 kV) power collection system and communications network.
At a substation, that medium-voltage electric energy is elevated in voltage with a transformer for link with the high voltage transmission system. Development of a land-based wind farm requires installation of the collector system and substation, and possibly access roads to each and every turbine site.
Facts about Digby Neck wind farm
- Name: Digby Neck
- Wind turbine Supplier: Neg Micon, Model: 0.108MW, Units: 115,
- Country: Canada
- Developer: Nova Scotia Power
- State: Nova Scotia
- City: Digby County
- Owner: Emera