Des Moulins I wind project was set up in Québec, Canada It was in fact brought online in 2014 and is owned by Invenergy.
It is near Kinnear’s Mills, Saint-Jean-de-Brébeuf and Thetford Mines municipalities.
See below for data.
Wind farms, as a general rule demand wind speeds of 4.5 metres per second or higher.
An ideal location for a project like Des Moulins I would have a near constant flow of non-turbulent wind all year round, having a minimum chances of sudden effective bursts of wind. Additionally, you would not get a turbine Invenergy like Invenergy associated if Des Moulins I was not built near local demand or transmission capaKinnear’s Mills, Saint-Jean-de-Brébeuf and Thetford Mines municipalities.
Before development, Des Moulins I was most likely screened on the foundation of a wind atlas, and validated with wind measurements. Meteorological wind data alone is usually not ample for correct siting of a large wind power project.
Site data around Kinnear’s Mills, Saint-Jean-de-Brébeuf and Thetford Mines municipalities would have been a major factor in the ‘development’ conclusion Local winds are often examined for a year or more, and detailed wind maps constructed before wind generators are set up.
The wind hits quicker at greater altitudes because of the reduced influence of drag. The surge in velocity with altitude is most remarkable at the surface and is affected by geography, surface roughness, and upwind hurdles such as trees or buildings. Velocity increases with altitude and is also more pronounced near land and is altered by topography, surface and obstructions.
Wind speeds increasing with altitude is part of a wind energy law. This Québecs wind speed rises with the 7th root of altitude. Increasing the altitude of a turbine, then, boosts the expected wind speeds by 10%, and the estimated power by 34%.
In general, a length of 7D (7 × Rotor Diameter of the Wind Turbine) is about between each turbine in a fully developed wind farm. But micrositing maximizes placement, particularly in hilly areas.
Des Moulins I turbines are linked via medium voltage lines and communications.
At a substation, this medium-voltage electric energy is elevated in voltage with a transformer for connection to the high voltage transmission system. Construction of a land-based wind farm requires installation of the collector system and substation, and perhaps roads to every turbine site.
Facts about Des Moulins I wind farm
- Name: Des Moulins I
- Wind turbine Supplier: Vestas Wind Systems, Model: 0MW, Units: 2,
- Country: Canada
- Developer: 3Ci
- State: Québec
- City: Kinnear’s Mills, Saint-Jean-de-Brébeuf and Thetford Mines municipalities
- Owner: Invenergy