Conestogo (NextEra) wind project was set up in Ontario, Canada It was finished in 2012 and is owned by .
It is near Mapleton Township, southwest of Arthur.
See below for data.
Wind farms, as a general rule require wind speeds of 4.5 metres per second or more.
A great destination for a project like Conestogo (NextEra) might have a near constant flow of non-turbulent wind all year round, with a minimum probability of sudden powerful bursts of wind. Additionally, you would not get a turbine like included if Conestogo (NextEra) was not built near local demand or transmission capaMapleton Township, southwest of Arthur.
Before building, Conestogo (NextEra) was almost certainly screened on the foundation of a wind atlas, and validated with wind specifications. Meteorological wind data alone is usually not ample for correct siting of a large wind power project.
Site information around Mapleton Township, southwest of Arthur would have been a major factor in the development choice Winds around Mapleton Township, southwest of Arthur are examined for over a year or so plus the development of detailed maps. Only then are wind turbines installed.
The wind hits quicker at higher altitudes because of the reduced influence of drag. The surge in velocity with altitude is most dramatic close to the surface and is affected by geography, surface roughness, and upwind hurdles such as trees or buildings. Velocity increases with altitude and it is more distinct near land and is transformed by topography, surface and obstacles.
Almost always, the rise of wind speeds with growing height follows a wind profile power law, which anticipates that wind speed rises proportionately to the seventh root of altitude. Increasing the altitude of a turbine, then, raises the predicted wind speeds by 10%, and the estimated power by 34%.
In general, a range of 7D (7 × Rotor Diameter of the Wind Turbine) is about between each turbine in a fully developed wind farm. But micrositing increases placement, specially in hilly areas.
Conestogo (NextEra) turbines are related via medium voltage lines and communications.
At a substation, this particular medium-voltage electric energy is enhanced in voltage using a transformer for link with the high voltage transmission system. Development of a land-based wind farm requires installation of the collector system and substation, and possibly access roads to each turbine site.
Facts about Conestogo (NextEra) wind farm
- Name: Conestogo (NextEra)
- Wind turbine Supplier: Mitsubishi Corporation, Model: 0.6MW, Units: 42,
- Country: Canada
- Developer: NextEra Energy
- State: Ontario
- City: Mapleton Township, southwest of Arthur