Bruges wind project was set up in Flemish Brabant, Belgium It was finished in 2004 and is owned by Electrawinds.
It is near Brugge – Pathoekeweg.
See below for data.
Wind farms, as a general rule demand wind speeds of 4.5 metres per second or higher.
The very best location for something such as Bruges would be a steady supply of non-turbulent wind. Additionally, you wouldn’t get a turbine Electrawinds like Electrawinds included if Bruges was not built near local demand or transmission capaBrugge – Pathoekeweg.
During the planning stages the Bruges wind farm would’ve been checked and endorsed through wind measurements. However, Bruges wind farm might have needed more than just meteorological data and measurements.
Site information around Brugge – Pathoekeweg is a major factor in the ‘development’ decision Local winds are frequently watched for a year or more, and detailed wind maps created before wind generators are installed.
Altitude would also possess a part to performin a project like Bruges. This is due to drag The increase in velocity with altitude is most extraordinary at the surface and is impacted by topography, surface roughness, and upwind obstacles such as trees or buildings. Velocity rises with altitude and is also more evident near land and is altered by topography, surface and obstacles.
Typically, the growth of wind speeds with growing elevation follows a wind profile power law, which forecasts that wind speed rises proportionately to the seventh root of altitude. Increasing the height of a turbine, then, enhances the expected wind speeds by 10%, and the predicted power by 34%.
In general, a range of 7D (7 × Rotor Diameter of the Wind Turbine) is about between each turbine in a fully developed wind farm. But this might not be the way it is in hilly areas.
Bruges turbines are linked via medium voltage lines and communications.
At a substation, that medium-voltage electric energy is increased in voltage using a transformer for link with the high voltage transmission system. Development of a land-based wind farm requires installation of the collector system and substation, and possibly roads to every turbine site.
Facts about Bruges wind farm
- Name: Bruges
- Wind turbine Supplier: Enercon, Model: E101/3000, Units: 7,
- Country: Belgium
- Developer: Electrawinds
- State: Flemish Brabant
- City: Brugge – Pathoekeweg
- Owner: Electrawinds